Before Using this Terminal
• This terminal supports LTE, W-CDMA, GSM/
GPRS and wireless LAN systems.
• Since this terminal uses wireless signal,
it may not be able to use in a location
with no signal reception such as a tunnel,
underground, a building, an outdoor location
with weak or poor signal reception, or a
location outside of the Xi and FOMA service
areas. Also this terminal may not be able
to use on high upper oors of high-rise
apartments or buildings, even if you can see
no obstructions around you. Please note
that on occasion, data communication may
become disconnected even when you are
in a strong-signal area with four signal bars
displayed while you are not moving.
• Since this terminal uses wireless signal,
there are possibilities that a third party may
intercept your telephone call. However, LTE,
W-CDMA and GSM/GPRS systems support
the privacy function covering all telephone
calls automatically. Therefore, even a third
party intercepts your telephone call, the third
party can hear nothing but the noise.
• Because this terminal conducts wireless
communication by transforming sound into
digital signal, the received sound may dier
from the actual one if the transmitted digital
signal cannot properly be restored according
to conditions such as moving into a poor
signal area.
• This terminal responds to FOMA Plus-Areas
and FOMA HIGH-SPEED Areas.
• Keep a separate record of any information
stored on this terminal and store the copies
in a safe location. DOCOMO assumes no
responsibility for any loss of your data caused
by malfunction, repair, change to a new model
or any other reasons.
• The same as a PC, when you install an
application, this terminal's performance may
become unstable, or your location information
and personal information registered on this
terminal might be sent to outside via Internet
and therefore cause fraudulent use. To avoid
this, make sure to conrm the source and the
operating conditions of the application before
installation.
• Even though the display on this terminal
applies advanced technique, part of the dots
may not light up as well as those always-on
light. Please note that this is a feature of the
display. It is not a malfunction.
6