7” round Retaining Ring and Bracket
for 7” replacement Motorcycle LED
Headlight
HE-HB7 (Retaining Ring)
Applications: 2013 and older Harley
Davidson’s with the 7” round
headlight
Tools Needed – Phillips Screwdriver
Instructions:
Refer to the motorcycle’s instructional manual for proper
headlight removal.
For most applications follow these steps:
1. Remove trim ring (if applicable) by removing (1) Phillips
screw at bottom of trim ring.
2. Remove (3) screws from the headlight retaining ring and
remove headlight.
3. Remove (4) screws from the headlight bracket and
remove bracket.
4. Install new HEISE headlight bracket with the previously
removed (4) screws.
NOTE: HEISE headlight bracket will come with foam
tape already installed on bracket to reduce vibration. If
installing the HE-BHL704 REMOVE the foam tape from
bracket.
5. Remove new retaining ring from bracket and install the
new LED headlight then reinstall the retaining ring with
the (3) screws.
6. Reinstall the trim ring (if applicable) around headlight
with the Phillips screw.
Specifications:
Zinc plated for corrosion resistance
1-800-221-0932 www.HeiseLED.com
460 Walker Street, Holly Hill, FL 32117
/
