2. Critical Environment Technologies
  3. Internal Silicone Heater
Internal Silicone Heater

Critical Environment Technologies Internal Silicone Heater User guide

  • Hello, I'm a chat assistant that has analyzed the provided document about Critical Environment Technologies transmitters LPT-A, ESH-A, LPT-M, CGAS-A and CGAS-D. This guide describes the internal silicone heater for cold environments. I can help you with any questions about the wiring, power requirements, or other features mentioned in the document.
  • What voltage is required to power the silicone heater?
    Does the heater have polarity?
    What is the power consumption of the heater?
Quick Reference Guide
Internal Silicone Heater used in CET Transmitters
The following CET transmitters may be ordered with an internal silicone heater for cold environment applications:
• LPT-A Analog Transmitter
• ESH-A Remote Sensor
• LPT-M Modbus Transmitter
• CGAS-A Detector
• CGAS-D Detector
The heater is xed to the inside of the enclosure on the base and requires an installer supplied, external 24V
power source to operate. The two blue wires have no polarity and can be connected to either terminal of a 24VAC
or 24VDC power source. The heater has a switch and will turn on and off appropriately to maintain operating
temperature inside the enclosure.
The heater requires 10W of power.
145 - 7391 Vantage Way, Delta, BC V4G 1M3 Canada
604.940.8741 1877.940.8741 [email protected]
www.critical-environment.com
110V
INSTALLER SUPPLIED 24VAC
OR 24VDC (NOMINAL) POWER
SOURCE
24VAC/24VDC
24VAC/24VDC
/