2. sonnax
  3. High Performance Driveline
High Performance Driveline

sonnax High Performance Driveline Operating instructions

  • Hello! I'm your chat assistant. I've reviewed the instructions for the Sonnax T9-28-1330FD Pinion Yoke. This document provides installation guidance, specifically regarding the spacer which is used with standard bearing carriers. I'm ready to answer any questions you have about this product based on the provided document.
  • What U-joint does this yoke use?
    When should I use the included spacer?
    Where should the spacer be installed?
Pinion Yoke
Part No.
T9-28-1330FD
• Yoke
• Spacer
NOTE: Fits all 9" Ford 28-spline
differentials.
Uses 1330 U-joint.
For 1350 U-joint, use T9-28-1350FD.
Spacer
Yoke
Figure 1
Bearing Width* Pinion Bearing O.D. Use Sonnax Spacer
Standard Carrier 2.2" 2.675" Yes
Big Bearing Carrier/Daytona 2.5" 3" No
*Bearing width is the width between outer bearing faces when installed in the carrier.
Figure 2
Spacer
*Bearing
"Width"
Pinion
Nut
Bearing Carrier
Pinion Gear &
Integral Shaft
Rear Bearing
Front Bearing
Pinion
Bearing O.D.
Pinion
Yoke
Standard Bearing Carrier
Carrier Bearing Identification & Spacer Use
NOTE:
The included Sonnax spacer is used only in standard (small) bearing carriers.
If you have a big bearing OE, or a Daytona carrier, do not use Sonnax spacer (Figures 1–3).
NOTE:
When using Sonnax spacer, always install behind the pinion nut (like a washer) (Figure 2).
This spacer is NOT intended to be installed between the yoke and bearing.
Figure 3
*Bearing
"Width"
Bearing Carrier
Pinion Gear &
Integral Shaft
Rear Bearing
Front Bearing
Pinion
Bearing O.D.
No
Sonnax Spacer
Pinion
Nut
Big Bearing Carrier
Pinion
Yoke
©2021 Sonnax Transmission Company, Inc. • A Marmon / Berkshire Hathaway Company T9-28-1330FD-IN 11-11-21
800-843-2600 • 802-463-9722 • F: 802-463-4059 • www.sonnax.com
Instructions
HIGH PERFORMANCE DRIVELINE PARTS
PERFORMANCE
/