Way Basics WB-STAND-2-WE Installation guide

Type
Installation guide

This manual is also suitable for

Help and Comments www.waybasics.com/contact
version 042017
Important
THIS SIDE UP
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
Middle Board
Side Boards
CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.
2
1
3
5
4
6
Align side zBoards to middle zBoard
and press firmly to secure unit together.
Carefully remove the protective layer
leave the 3M adhesive on zBoard and
insert pins.
Align top zBoard to unit as shown.
Press down firmly to secure.
Enjoy building possibilities!
With adhesive on zBoard all facing same
direction, align left and right Backboard
to side zBoards.
Carefully remove the protective layer
leaving the 3M adhesive on zBoard
(adhesive shown in yellow).
Insert pins as shown.
Backboards
2 Backboards
adhesive strips on 2 edges
1 Middle zBoard
adhesive strip on 2 side edges
1 Top zBoard
2 Side zBoards
adhesive strips on top edge
14 Pins
Included
2 SHELF MONITOR STAND
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
  • Page 1 1

Way Basics WB-STAND-2-WE Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages