Kichler Lighting 42593OZ User manual

Brand
Kichler Lighting
Model
42593OZ
Type
User manual
Date Issued: 06/24/16 IS-42593-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fuse
box before starting and during the installation.
STEM DROP INSTALLATION
1) Pass fixture wire through center stem with hexnut. Screw
longer threaded end of center stem into coupling on top of
wiring body. Tighten hexnut to secure stem in place.
2) Pass fixture wire through the tube. Slide tube over center
stem and rest into bottom check-ring.
3) Pass fixture wire through check-ring (open side faced
down). Rest check ring on top of the tube.
4) Pass fixture wire from top of fixture body through center
hole in canopy. Pass center hole in canopy down over end
of threaded pipe on top of fixture.
5) Pass fixture wire through lockwasher. Thread lockwasher
down over end of threaded pipe protruding from inside
canopy.
6) Pass fixture wire through ground lug. Slip ground lug onto
threaded pipe protruding from inside canopy.
7) Pass fixture wire through lockwasher. Thread lockwasher
down over end of threaded pipe protruding from inside
canopy.
8) Pass fixture wire through hole in hexnut. Thread hexnut onto
threaded pipe protruding from inside canopy. Tighten to
secure.
9) Raise arm up to canopy. Slip threaded end into hole in
canopy.
10) Thread lockwasher down over end of arm protruding from
inside canopy.
11) Thread hexnut onto arm protruding from inside canopy.
Tighten to secure arm in place.
12) Repeat steps 9-11 for remaining arms. Space arms evenly
from each other at 120 degrees.
13) Find the appropriate threaded holes on mounting strap. As-
semble mounting screws into threaded holes.
14) Attach mounting strap to outlet box. Mounting strap can be
adjusted to suit position of fixture.
15) Grounding instructions: (See Illus. A or B).
A) On fixtures where mounting strap is provided with a
hole and two raised dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B) On fixtures where a cupped washer is provided. Attach
ground wire from outlet box under cupped washer and
green ground screw, and thread into mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector,
after following the above steps. Never connect ground wire
to black or white power supply wires.
16) Make wire connections. Reference chart below for correct
connections and wire accordingly.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
17) Push fixture to ceiling, carefully passing mounting screws
through holes in canopy. NOTE: Be certain wires do not get
pinched between mounting plate and canopy.
18) Slip lockwashers over mounting screws. Thread lock-up
knobs onto mounting screws. Tighten lock-up knobs to
secure fixture to ceiling.
19) Insert recommended bulbs. (Not supplied)
20) Overlap end of support strap (with bends) onto the notch on
the end of another strap. Connect all three straps around the
upper curve of the glass.
21) Carefully the raise glass up to fixture, passing the sockets.
Raise the glass until the strap is parallel with the mounting
stems of the arms. (The top lip of the glass will hang over the
mounting stems)
22) Fit the mounting stem of the arm onto a notch on the strap.
23) Screw the ball stud into the mounting stem / strap. Tighten
ball stud to secure the arm to the strap.
24) Repeat steps 22 & 23 for the remaining arms.
Date Issued: 06/24/16 IS-42593-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fuse
box before starting and during the installation.
OUTLET BOX
WIRE
CONNECTOR(S)
STRAP
MOUNTING SCREW(S)
MOUNTING
SCREW(S)
MOUNTING
STRAP
HEXNUT(S)
LOCKWASHER(S)
LOCK-UP
KNOB(S)
GROUND
LUG
ARM(S)
CHECK
RING
TUBE
MOUNTING
STEM
BALL
STUD
CENTER
STEM
HEXNUT
COUPLING
SOCKET
GLASS
  • Page 1 1
  • Page 2 2

Kichler Lighting 42593OZ User manual

Brand
Kichler Lighting
Model
42593OZ
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents