Engineered and Distributed by AUDIO TELEX COMMUNICATIONS PTY LTD (ABN 78 001 345 482), 149 Beaconsfi eld Street, Silverwater, Sydney, NSW, 2128 Australia
NSW Tel: (02) 9647 1411 Fax: (02) 9648 3698 VIC Tel: (03) 9890 7477 Fax: (03) 9890 7977 QLD Tel: (07) 3852 1312 Fax: (07) 3252 1237 WA Tel: (08) 9228 4222 Fax: (08) 9228 4233
SA
Tel: (08) 8352 4444 Fax: (08) 8352 4488 NZ Tel: (09) 415 9426 Fax: (09) 415 9864 International Enquiries - [email protected] www.australianmonitor.com.au2 RU Stereo Power Amplifi ers
IS600, IS1200 & IS1600
The amplifi er shall be 2 RU dual channel with low impedance output of 300 watts per
channel at 4 ohms/600 watts per channel @ 4 ohms/ 800 watts per channel @ 4 ohms.
The amplifi er will have two dual speed fans, short circuit, overload, soft start & thermal
protection. Have switch operable ground lift, stereo/parallel operation, input gain sensitivity.
Inputs shall be balanced XLR or 6.35mm TRS type & speaker outputs
shall be Speakon or binding post type.
The amplifi er shall be the IS600/IS1200/IS1600
IS600 Specifi cations
Output @ 8 ohms 2 x 200 watts
Output @ 4 ohms 2 x 300 watts
Frequency Response <10Hz - >50kHz (-3dB)
THD <0.03% @ 1kHz
Crosstalk 60dB
Damping Factor 250 into 8 ohms/ 125 into 4 ohms
Input Impedance 20Kohm
Signal/noise ratio >99dB 20Hz-20kHz
Weight 20KG
Shipping Dimensions (wxdxh) 635mm x 590mm x 160mm
IS1200 Specifi cations
Output @ 8 ohms 2 x 400 watts
Output @ 4 ohms 2 x 600 watts
Frequency Response <10Hz - >50kHz (-3dB)
THD <0.03% @ 1kHz
Crosstalk 60dB
Damping Factor 250 into 8 ohms/ 125 into 4 ohms
Input Impedance 20Kohm
Signal/noise ratio >105dB 20Hz-20kHz
Weight 25KG
Shipping Dimensions (wxdxh) 635mm x 590mm x 160mm
IS1600 Specifi cations
Output @ 8 ohms 2 x 500 watts
Output @ 4 ohms 2 x 800 watts
Frequency Response (-3db) <10hz - >50khz (-3dB)
THD <0.03% @1 Khz
Crosstalk 60dB
Damping Factor 250 into 8 ohms/ 125 into 4 ohms
Input impedance 20kohm
Signal/noise ratio >90dB 20Hz-20kHz
Weight 22.0KG
Shipping Dimensions (wxdxh) 483mm x 452mm x 89mm
Architecture & Engineering Specifi cations
AMIS•600-1200-1600.indd 2AMIS•600-1200-1600.indd 2 20/2/06 4:39:50 PM20/2/06 4:39:50 PM