SP8017-1007
EVOLUTION ELECTRIC STEAMER
PAGE 4
LEVELING
-
-
of the stand
GROUNDING INSTRUCTIONS
Grounding provides a path for electric current to
reduce risk of shock. This product is equipped with a
power pack. The power pack must be plugged into a
receptacle that is properly installed and grounded in
accordance with all National, State and local electrical
codes or in the absence of local electrical codes with
theNationalElectricCode,ANSI/NFPA70,orthe
Canadian Code, CSA C22.2 as applicable. Under no
circumstances shall the plugs grounding prong be cut
orbenttotareceptacleotherthantheonespecied.
Do not use any adapters.
DANGER
This appliance Must be properly grounded, in
accordance with all National, State and local
electrical codes.
DANGER
Any in-eld modication made that bypass the
safety features of this appliance will result in
serious injury or death.
WARNING
Any in-eld modications made without written
authorization from AccuTemp Products, Inc. will
void all written and oral warranties.
ELECTRICAL REQUIREMENTS
ELECTRICAL INSTALLATION
POWER REQUIREMENTS AC power
requirements are listed on the data plate located
on the left side access panel on all Evolutions.
This appliance should never be connected to a
circuit operating at more than 150 VAC to ground
and should always be connected to an individual
branch circuit. Make sure the voltage at the
supply receptacle is within ±10% of the voltage
listed on the Evolution data plate. Connection
to any other voltage may permanently damage
your appliance or cause premature component
failure. Damage of this type is not covered under
the product warranty. Each Evolution Electric
appliance for ESPEK comes equipped with a
power pack with a internal breaker that is rated
for the power requirements of each appliance.
Damage caused by removal or modication of
pf the power pack is not covered by appliance
limited warranty.
WARNING
Only personnel qualied to work with electricity
should install this equipment. Improper
installation can cause personal injury or damage
to the equipment.
INSTALLATION