Mellanox Technologies SX6025 Quick Installation Manual

Type
Quick Installation Manual

This manual is also suitable for

www.mellanox.com
Mellanox InfiniBand
1U Switch Systems
Quick Installation Guide
Models: SX6015, SX6018, SX6025, SX6036,
SX6036G
2
Pay Attention!
All servers and systems in the rack should be planned with the airflow
direction. All FRU components must have the same air flow direction. A
mismatch in the air flow will affect the heat dissipation.
The FRUs are extractable. The rails should be attached to the ports side
of the system, so this side is adjacent to the cabinet. This will allow you
to slide the FRUs, in and out.
Package Contents
•1 x System
Rail Kit for short depth (17”-24” / 432-610mm) or standard depth (24”-
34” / 610-863mm) racks
1or 2 (according to order) x Power cables – Type C13-C14
1 x Harness RS232 2M cable – DB9 to RJ-45 (for managed systems
only)
•Quick Start Guide
If anything is damaged or missing, contact your Mellanox representa-
3
Package Contents
10X
10X
16X*
1X
1X
1/2X**
2X
2X
2X
* 14X screws for use + 2X spare units
**According to customer order
Mellanox Technologies
5
1
2
Mellanox Technologies
6
3
4
Mellanox Technologies
7
5
8
Connector (Front) Side
Externally Managed Systems
FRU (Rear) Side
* It may take up to five minutes to turn on the system. If the System Status LED shows red after
five minutes, unplug the system and contact your Mellanox representative.
9
LED Assignments
Configuration
For full installation instructions, go to http://www.mellanox.com/-->Products-->
InfiniBand/VPI Switch Systems
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Mellanox Technologies SX6025 Quick Installation Manual

Type
Quick Installation Manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI