www.mellanox.com
Mellanox Ethernet
1U Switch Systems
Quick Installation Guide
Model: SX1012, SX1012X
2
Pay Attention!
• All servers and systems in the rack should be planned with the airflow
direction. All FRU components must have the same air flow direction. A
mismatch in the air flow will affect the heat dissipation.
Package Contents
System Package
•1 x System
• 1or 2 (according to order) x Power cables – Type C13-C14
• 1 x Harness RS232 2M cable – DB9 to RJ-45 (for managed systems
only)
Rail-kit Package
• 1 x 2-System metal frame - fits into racks with from 21” (533mm) to 34”
(864mm) between the vertical supports.
• 4 x system mounting rails - The kit contains enough rails to install 2
systems.
• 10 x M-5 Pan head screws
• 24 x flat head screws - The kit contains enough screws to install 2 sys-
tems.
• 10 x spacer bushing for frame installation
•1 x blank cover
• 4 x rubber stick-on feet. Not used for side by side installation
•Quick Start Guide
If anything is damaged or missing, contact your Mellanox representa-
tive at [email protected].
3
Package Contents
10X
10X
24X*
1X
1/2X**
2X
* The kit contains enough screws and rails to install 2 systems
**According to customer order
1X
2X
4X*
1X
System’s Package:
Mellanox Technologies
5
1
2
Mellanox Technologies
6
3
4
Mellanox Technologies
7
5
6
Mellanox Technologies
8
7
10
Connector (Front) Side
FRU (Rear) Side
* It may take up to five minutes to turn on the system. If the System Status LED shows red after
five minutes, unplug the system and contact your Mellanox representative.
11
LED Assignments
Configuration
For full installation instructions, go to http://www.mellanox.com/-->Products-->
Ethernet Switch Systems
/