Warranty & Support
This product is provided with a one year warranty for problems found during
normal usage. Mistreating the Communication Headset or opening the unit will
invalidate this warranty. Any data stored on the unit and any consequential loss
is not covered by this warranty. The battery is not user replaceable.
Technical Support
Please visit www.tts-group.co.uk for the latest product information.
Email [email protected] for technical support.
TTS Group Ltd.
Park Lane Business Park
Kirkby-in-Ashfield
Nottinghamshire,
NG17 9GU, UK.
Freephone: 0800 318686 Freefax: 0800 137525
TTS Product Code:
EY06489
WARNING: Do not dispose of this product in household
waste. Hand it over to a collection point for recycling
electronic appliances.
WARNING! Not suitable for children under 36 months
due to small parts – choking hazard. Made in China,
on behalf of the TTS Group Ltd.
Communication
Headset
TM
USER GUIDE
Nxxxxx
N448
TTS is proud to be part of plc
5V
COMMUNICATION HEADSET MANUAL 3/12/14.indd 1 18/12/2014 16:17
Great for Communication outdoors
Communication
Headset
TM
USER GUIDE
TTS is proud to be part of plc
COMMUNICATION HEADSET MANUAL 3/12/14.indd 2 18/12/2014 16:17
Important information
Please retain these instructions for future reference, as they contain important
information.
Use only the provided power adaptor.
The supply terminals are not to be short-circuited.
Do not allow the Communication Headsets to come into contact with water or
other liquids.
Keep the Communication Headsets away from direct sunlight and heat.
In the event of electrostatic discharge your Communication Headsets may
malfunction – please refer to the trouble shooting section for guidance on resetting
the units.
It is recommended that Communication Headsets are switched off when not in
use.
Know your Communication Headsets
On/Off Switch
Press to talk
Reset Button
Pairing Button
COMMUNICATION HEADSET MANUAL 3/12/14.indd 3 18/12/2014 16:17
Communication Headset
TM
Using your Communication Headsets
Volume Adjustment
The Communication Headsets have a volume control on the headset. The
volume control is located on the right hand side ear cup, towards the back of the
headset. The control is raised slightly so it can be easily located without the need
to remove the headset during use.
Switching On and Off
To switch on, slide switch into the ON position. The status LED will light green
to indicate that they are ready to transmit and receive. Repeat these steps with
the other headsets. To switch off, slide the switch to OFF. The LED will turn off to
indicate headsets have fully switched off.
To Communicate
A green LED will indicate that the Headsets are ready to use. To talk, push the
button (microphone icon) on the right cup of the headsets. A solid Amber LED
will indicate headsets are communicating. The user wearing the other headset
should hear the sound from the first headset. As with all walkie-talkies the
Communication Headsets are half-duplex. This means both users cannot speak
at the same time and will need to alternate pressing the microphone button.
If the LED indicates an alternating red and green flashing light this means that the
destination headset is switched off.
Charging
When fully charged the Communication Headset will have a battery life of
approximately 10 hours continuous use (depending on distance and volume
setting). When the Communication Headset requires recharging, the status LED
will flash red to indicate low battery. To charge the Communication Headsets,
connect all the Headsets to the charger using the leads and splitter provided. The
statues LED will change to red to show they are charging. Once fully charged the
status LED will change to green.
COMMUNICATION HEADSET MANUAL 3/12/14.indd 4 18/12/2014 16:17
LED Indication
Green - Power on
Red (flashing) - Low battery. Headsets needs charging
Red (solid) - Battery charging
Green (solid) - Battery charged
Amber (solid) - Communicating
Amber (flashing) - Pairing
Green and red (flashing) - Receiving headset switched off.
Replacing the Ear cushions
The headset cushions can be removed and replaced with new ones (Available
from TTS product code EL00413)
The headset cushions can be removed and replaced with new ones (Available
from TTS product code EL00413)
To remove: Grip the ear pad firmly and rotate anticlockwise 1/8th turn. The whole
ear pad assembly can then be removed. To replace: Locate the lugs on the ear
pad assembly into the headset, and then rotate clockwise 1/8th turn until it clicks.
International Charging Adaptor
The Communication Headsets are supplied with a multi-region adaptor. The
adaptor is supplied with the UK plug fitted but this can easily be switched to suit
any country. Press the release button behind the plug head and rotate the plug
anti-clockwise to remove it.Replace with the desired plug head and rotate clock-
wise until it clicks into place securely.
The safety isolating transformer to be used with the product should be regularly
examined for potential hazards such as damage to the cable, cord, plug,
enclosure or other parts. In the event of any damage, the adaptor must not be
used until the damage has been properly repaired.
COMMUNICATION HEADSET MANUAL 3/12/14.indd 5 18/12/2014 16:17
Troubleshooting
In the first instance always check the units are fully charged, switched on and the
volume not set to zero.
If for any reason the Headsets malfunction, switch the units off, wait for 10
seconds and switch them back on again. If this doesn’t resolve the issue the
Headsets may have become unpaired. To re-pair the units complete BOTH (1) and
(2) below:
Reset the Headsets
Press the reset button. Green LED will flash once, indicating that it’s reset
Pairing
Press the pairing button of Headset A, amber LED will flash. Then press pairing
button of headset B, its amber LED will flash, Headset (A /or B) will search for
Headset (B/or A), LED will change to green when pairing is completed.
Communication Headset
TM
Specifications
100 – 16KHz
16K – 20KHz
-30dB (± 3dB)
650mAH Lithium Polymer
10 hours (Typical)
Speaker frequency response
Microphone frequency response
Microphone sensitivity
Battery
Battery Life
Technical Specification
COMMUNICATION HEADSET MANUAL 3/12/14.indd 6 18/12/2014 16:17
/
