2. luminii
  3. Katana Wet

luminii Katana Wet Installation guide

  • Hello! I've reviewed the Luminii installation instructions for the Katana Wet light fixture, model KATW-. This document outlines the steps for safe and correct installation, including mounting, wiring, and dealing with the protective film on the lens. The fixture is suited for use in wet locations and closet storage spaces. I'm ready to answer your questions about it.
  • What type of power supply should be used?
    Can this product be installed in wet locations?
    Where else this product can be installed?
Page 1 of 1
REV0.2
Katana Wet - Installation Instructions
Model KATW-
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS & INSTRUCTIONS WITHOUT NOTICE
4002302
Conforms to ANSI/UL STD 2108
Certified to CAN/CSA STD C22.2
No. 250.0-08
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. Use only with Class 2 power supply.
4. Suitable for wet locations, must use appropriate weatherproof rated wire connectors.
5. Suitable for installation within the closet storage space.
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
12
Katana light fixture body
Use the dimensions above for reference, when mounting to the
surface.
2.06”
0.31”
0.66” 0.70”
0.70”
mounting
brackets
mounting
screws
wires to
power
supply
Align the fixture to the determine location,
(low voltage power wires must be present prior to
installing). Secure by tightening the two screw
through the mounting brackets to the drywall.
Ensure power is off to power supply!
Then proceed to connect wires from Katana light fixture to
power supply. Connection can be established with lead wires or
quick-connect powerfeed. For more information please refer to
power supply wiring instructions.
power to Katana
light fixture
24VDC class II
power supply
120VAC line
voltage wires
24VDC low voltage
wires
3
lens
Remove the protective film from the diffuser lens.
film
4
/