2. OTC
  3. 6582

OTC 6582 Assembly Instructions

  • Hello! I've analyzed the provided document, which is a parts list and assembly instruction for the OTC StrutTamer II Stand model 6582. This stand is designed for use with OTC StrutTamer models 6580, 6591, and 6637. The document includes details on assembling the stand, including mounting the legs, frame, wheels, and tool tray. It also includes details on parts needed to assemble the stand. Feel free to ask me any questions you have about the assembly process or the components.
  • How are the rubber bumpers attached to the legs?
    How to mount the StrutTamer II to the stand?
    Where is the tool tray installed?
Form No. 520561
Parts List &
Assembly Instructions
for: 6582
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
II Stand
(designed for OTC StrutTamer No. 6580, 6591, 6637)
Item Part
No. No. Qty. Description
1 527697 8 Hex Locknut (M12 x 1.75)
2 218920 2 Hex Hd. Cap Screw
3 223328 1 Tool Tray
4 526433 1 Decal
5 527573 2 Flex Grip Handle
6 527698 2 Hex Hd. Cap Screw
(M12 x 1.75 x 120)
7 205727 2 Wheel (4" dia.)
8 212336 4 Cap Screw
9 223270 4 Rubber Bumper
10 527700 4 Hex Nut (1/4-20 UNC)
11 527699 4 Machine Screw
Parts List
Assembly Instructions
(Item numbers refer to the parts list.)
1. Insert machine screws (11) through rubber bumpers (9), and use hex nuts (10)
to attach rubber bumpers to legs.
2.
Attach legs to cross member using cap screws (8) and hex locknuts (1).
Use cap
screws (8) and locknuts (1) to attach wheels (7) to legs.
3. Position vertical frame between tangs in cross member, with StrutTamer II
mounting holes toward front of stand as shown. Use cap screws (6) and locknuts
(1) to attach frame to tangs.
4. There are three pairs of mounting holes which may be used to mount the
StrutTamer II to the mobile stand. Select one pair which would hold the StrutTamer
II at the desired height after assembly. Use cap screws (2) and locknuts (1) to
assemble StrutTamer II to stand.
5.Thetooltray(3)isdesignedtobeoffsettothebackofthestand,andushwith
the front of the frame, so it doesn't interfere with the StrutTamer II. Install tool
tray by pushing mounting tangs into frame.
Install tray offset to back
of stand and ush with
front of frame.
vertical
frame
cross
member
leg
Sheet 1 of 1
Rev. C, December 21, 2017
© Bosch Automotive Service Solutions Inc.
1, 2
3
1
5
1, 6 7
8
9, 10, 11
Use top two holes in
StrutTamer II body to
mount StrutTamer II on
stand.
T M
4
/