Manual # 650654
7. Secure the VLC clock assembly and the headlight switch assembly to the stock gauge bezel using a
5/64 allen wrench. Be careful not to overtighten the set screws and take care when routing the CAT5
cable to the control box mounting location.
5. Disassemble the clock; the only parts that will be reused are the bezel and the mounting clip. The
lens and trim is swaged in place so the tabs will need to be ground down so they can be removed.
Pay attention to the mounting clip orientation so it can be reassembled in the same fashion.
6. Secure the VLC clock into the clock bezel using the supplied screws. Make sure to orientate the
clock mounting tab on the back of the VLC clock in the same direction from disassembly. Connect
the 60” CAT5 cable as well as the VLC power harness to the back of the VLC clock.