Installation instructions
Built-in switch box
J10C.113-1
27.6.14 AGDA
1
These installation instructions apply to the model: 10C, 11C
Identification plate
A Affix the second identification plate (supplied) in an accessible position behind the front of the fitted cabinet beneath the appliance.
A Refer to the identification plate for specifications for the required mains voltage, current type and fuses.
A The appliance is equipped with a mains cable that should be connected to a distribution box by the customer.
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be
strictly observed.
Electrical connections
Electrical connections must made by qualified personnel in accordance with the guidelines and standards for low voltage
installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. An
all-pole mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and
socket devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching
are permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and
fault-free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should
always be checked.
Installation instructions
Built-in switch box
J10C.113-1
27.6.14 AGDA
2
* Allow an air gap of at least 25 cm
2
across the entire width of the element for adequate air circulation.
A Make 42 mm diameter bore holes for mounting the dial to the front side of the base unit as shown in the illustration. The retaining
plate (A) can be used as a bore aid.
A Hold the retaining plate (A) from the back against the kitchen front.
A Insert the dials (B) into the bore holes from the front and tighten at the back using the nuts (C).
A Secure the switch box (D) to the retaining plate using the enclosed screws (E).
A Make earth connection (F).
A Firmly insert the connecting cable (G) from the appliance and dials (plugs must engage).
Preparing the fitted cabinet
Installing the switch box
This appliance may only be installed together with the switch box with the same type designation.
Before connecting the appliance, turn off the power at the fuse or circuit breaker!
The correct layout of the cooking zones is defined by the retaining plate (A).
9
2
42
9
2
9
2
600
15–2620
5*
min. 60
560
min. 400
135
60
min. 38 min. 103
model11C
A
7
8
9
6
-
9
Only for ESIE4,
Intermediate base only
removable with tools
8
7
9
9
-
8
7
9
9
-
8
7
9
9
-
8
7
9
9
-
B
A
C
9
8
7
9
-
9
8
7
9
-
9
8
7
9
-
9
8
7
9
-
E
D
F
G
/
