Whirlpool CABINET DEPTHSIDE BY SIDEREFRIGERATOR User manual

Category
Fridges
Type
User manual

This manual is also suitable for

Counter Depth, Side by Side Refrigerator
®
PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
CABINET OPENING DIMENSIONS
DOOR SWING DIMENSIONS
Electrical: A 115-volt, 60-Hz, AC-only 15- or
20-amp fused, grounded electrical supply is
required. It is recommended that a separate circuit
serving only your refrigerator be provided. Use an
outlet that cannot be turned off by a switch. Do not
use an extension cord.
Water Supply: A cold water supply with water
pressure of between 30 and 120 psi (207 and
827 kPa) is required to operate the water dispenser
and ice maker.
IMPORTANT: The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 30 and 120 psi (207 to 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to be
a minimum of 40 to 60 psi (276 to 414 kPa).
The cabinet depth refrigerator can be installed into
a recessed opening, at the end of cabinets or as a
freestanding refrigerator.
Do not install the refrigerator near an oven, radiator,
or other heat source, nor in a location where the
temperature will fall below 55°F.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 2318510B
09-18-08
KSCS23FT
KSCS25FT
KSCS25FV
KSCS23FV
KSCK23FV
KSCK25FV
36"
(91.5 cm)
13¹⁄₄"
(34 cm)
16¹⁄₂"
(42 cm)
A
13⁵⁄₈"
(34.5 cm)
41³⁄₄"
(106 cm)
2⁵⁄₈"
(6.6 cm)
¹⁄₂ "
(12.7 mm)
17"
(43.0 cm)
0"
(0.1 mm)
45¹⁄₂ "
(115.6 cm
)
90˚
150˚
A. Dimensions may vary based on the model
24"
(61.0 cm)
27¹⁄₂"
(69.7 cm)
30¹⁄₈"
(76.4 cm) max.
35⁵⁄₈"
(90.5 cm)
A
15⁵⁄₈"
(39.6 cm)
19¹⁄₂"
(49.5 cm) 2⁵⁄₈"
(6.7 cm) max.
³⁄₈"
(95.3 mm)
35¹¹⁄₁₆"
(90.6 cm)
A
3⁵⁄₈"
(9.2 cm)
Height "A" Height "A"
Model size Standard Cabinet Full-overlay*
23 cu.ft. (654 L) 69" (175.3 cm) 69-1/8" (175.6 cm)
25 cu.ft. (694 L) 72" (182.9 cm) 72-1/8" (183.2 cm)
Height dimensions are shown with the
leveling legs extended to the minimum
height of 1/4" (6.35 mm) below the
refrigerator.
When leveling legs are fully extended to
1" (25 mm) below the refrigerator, add 3/4"
(19 mm) to the height dimensions.
The power cord is 66" (167.7 cm) long.
The water line attached to the back of the
refrigerator is 78" (198.1 cm) long.
Height dimensions are shown with the leveling legs extended to
the minimum height of 1/4" (6.35 mm) below the refrigerator.
NOTE: When leveling legs are fully extended to 1" (25 mm)
below the refrigerator, add 3/4" (19 mm) to the height
dimensions.
Minimum fixed wall position is 13-1/4" (34 cm) from the freezer
door and 16-1/2" (42 cm) from the refrigerator door.
*For full-overlay cabinet doors with a trim kit, the opening height
must be adjusted as shown.
Location must permit doors to open to a
minimum of 150°. Allow 13-1/4" (34 cm)
minimum space between the side wall
and the freezer side of the refrigerator.
Allow 16-1/2" (42 cm) minimum space
between the side wall and the
refrigerator side.
NOTE: Dimensions may vary based on
model.
21¹⁄₄"
(54.1 cm)
66"
(167.7 cm)
3⁵⁄₈" (9.2 cm)
C
AB
21¹⁄₄"
(54.1 cm)
66"
(167.7 cm)
3⁵⁄₈" (9.2 cm)
C
AB
Model Size Height A
23' (654 L)
25' (694 L)
64⁷⁄₈"(164.8cm)
67³⁄₄" (172.1 cm)
When leveling legs are fully extended to 1" (25 mm) below the
refrigerator, add ³⁄₄" (19 mm) to the height dimensions.
Model Size A B C
23'
(654 L)
68³⁄₄"
(174.6 cm)
68⁷⁄₈"
(175.0 cm)
68¹⁄₂"
(174.0 cm)
25'
(694 L)
71³⁄₄"
(182.2 cm)
71⁷⁄₈"
(182.5 cm)
71¹⁄₂"
(181.6 cm)
Top View
Front View
Side View
  • Page 1 1

Whirlpool CABINET DEPTHSIDE BY SIDEREFRIGERATOR User manual

Category
Fridges
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI