Whirlpool GC5SHAXV User manual

Whirlpool
Brand
Whirlpool
Model
GC5SHAXV
Category
Fridges
Type
User manual

This manual is also suitable for

Counter Depth, Side by Side Refrigerator
PRODUCT DIMENSIONS
CABINET OPENING DIMENSIONS
DOOR SWING DIMENSIONS
Electrical: A 115 Volt, 60 Hz., AC only 15 or 20
amp fused, grounded electrical supply is required.
It is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not use an
extension cord.
Water Supply: A cold water supply with water
pressure of between 30 and 120 psi (207 and
827 kPa) is required to operate the water dispenser
and ice maker. If you have questions about your
water pressure, call a licensed, qualified plumber.
IMPORTANT: The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 30 and 120 psi (207 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa).
The cabinet depth refrigerator can be installed into
a recessed opening, at the end of cabinets or as a
freestanding refrigerator.
Do not install the refrigerator near an oven, radiator,
or other heat source, nor in a location where the
temperature will fall below 55°F (13°C).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 2223996 Rev. B
09-20-08
36"
(91.5 cm)
13
¹⁄₄"
(34 cm)
16
¹⁄₂"
(42 cm)
A
13⁵⁄₈"
(34.5 cm)
41
³⁄₄"
(106 cm)
2
⁵⁄₈"
(6.6 cm)
¹⁄₂ "
(12.7 mm)
17"
(43.0 cm)
0"
(0.1 mm)
45¹⁄₂ "
(115.6 cm
)
90˚
150˚
A. Dimensions may vary based on the model
24"
(61.0 cm)
27¹⁄₂"
(69.7 cm)
30¹⁄₈"
(76.4 cm) max.
35⁵⁄₈"
(90.5 cm)
A
15⁵⁄₈"
(39.6 cm)
19¹⁄₂"
(49.5 cm)
2
⁵⁄₈"
(6.7 cm) max.
³⁄₈"
(95.3 mm)
21¹⁄₄"
(54.1 cm)
66"
(167.7 cm)
3⁵⁄₈" (9.2 cm)
C
A
B
35¹¹⁄₁₆ "
(90.6 cm)
A
3⁵⁄₈"
(9.2 cm)
Model size Door Height "A" "B" "C" "D"
23 cu.ft. (654 L) 64-7/8" (164.8 cm) 68-3/4" (174.6 cm) 68-7/8" (175 cm) 68-1/2" (174 cm)
25 cu.ft. (694 L) 67-3/4" (172.1 cm) 71-3/4" (182.2 cm) 71-7/8" (182.5 cm) 71-1/2" (181.6 cm)
Height "A" Height "A"
Model size Standard Cabinet Full-overlay*
23 cu.ft. (654 L) 69" (175.3 cm) 69-1/8" (175.6 cm)
25 cu.ft. (694 L) 72" (182.9 cm) 72-1/8" (183.2 cm)
■ Height dimensions are shown with the
leveling legs extended to the minimum
height of 1/4" (6.4 mm) below the
refrigerator.
When leveling legs are fully extended
to 1" (25 mm) below the refrigerator,
add 3/4" (19 mm) to the height
dimensions.
■ The power cord is 66" (167.7 cm) long.
■ The water line attached to the back of
the refrigerator is 78" (198.1 cm) long.
■ Height dimensions are shown with the leveling legs
extended to the minimum height of 1/4" (6.4 mm) below
the refrigerator.
NOTE: When leveling legs are fully extended to 1"
(25 mm) below the refrigerator, add 3/4" (19 mm) to the
height dimensions.
■ Minimum fixed wall position is 13-1/4" (34 cm) from the
freezer door and 16-1/2" (42 cm) from the refrigerator door.
*For full-overlay cabinet doors with a trim kit, the opening height
must be adjusted as shown.
A
B
C
D
PRODUCT MODEL NUMBERS
GC3JHAXT
GC3SHEXN
GC5SHEXN
GC3SHAXV
GC5SHAXV
®
Location must permit
doors to open to a
minimum of 150°. Allow
13-1/4" (34 cm) minimum
space between the side
wall and the freezer side of
the refrigerator. Allow
16-1/2" (42 cm) minimum
space between the side
wall and the refrigerator
side.
NOTE: Dimensions may
vary based on model.
Front view
Side view
Top view
  • Page 1 1

Whirlpool GC5SHAXV User manual

Whirlpool
Brand
Whirlpool
Model
GC5SHAXV
Category
Fridges
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents