Page is loading ...
Riley Large Floor Lamp
Item # RL 1493
ASSEMBLY INSTRUCTIONS
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Install lamp body (F) to base (L), then secure with lock washer (G)
and hex nut (H) using provided wrench (I).
3. Remove backing sheet from felt paper (J), then neatly apply to bottom
side of lamp base.
4. Install harp (C) onto saddle (E), adjust to desired height, then tighten
adjustment knobs (D).
5. Remove finial (A) from harp (C).
6. Remove shade (B) from packaging and attach to harp (C) using
finial (A).
NOTE: If shade has additional packaging, carefully cut off from
interior of shade to avoid damages.
7. Place diffuser (M) onto top of shade (B).
8. Install light bulb into the socket.
9. Remove protective cover (K) from the plug.
10. Plug into electrical outlet and test fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
NOTICE:
B (Packaged separately)
D
E
C
F
K
L
I
J
G
H
A
M
Bulb not included
TOOLS REQUIRED (NOT INCLUDED):
Scissors
US
M
L
I
D
S
E
T
LED
/
