2. BLOTZ
  3. B28-SF-225

BLOTZ B28-SF-225 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the BLOTZ Barricade B28-SF-225. This document provides step-by-step guidance on building 28mm scale barricades, including instructions for using glue and other tools. I'm ready to answer any questions you have about the assembly process or the product itself.
  • What is required for assembly?
    Can I use pegs or elastic bands during the construction?
    What should I do with the joints?
28mm Barricades
B28-SF-225
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the base and centre board from the sprue.
Glue the centre board to the base as shown above.
Take the back board and angle brackets…
..and glue them into position (see pic).
Glue back plate to the centre board, using the holes to
align the lugs on the angle brackets.
Take the front plate and centre piece from the
sprue.
Attach them to the front of the model as shown.
The finished barricades.
/