(888) 782-5618
Figure 1:
• Press the switch under light fixture to "ON"
position.
Figure 2:
• Choose desired wall location. Drill two holes on
the wall. Insert the plastic anchors and screw the
screws into the wall, leaving about 2mm long
thread.
• Hang the light on the screws with the mounting
holes
Note: Lights with solar panel may have a protective
film over the solar panel. This must be removed
prior to use.
Note: It is best that the light fixture is mounted
approximately 6.5 ft. (2m) above the ground.
1. Use a damp cloth to clean the solar panel
2. To avoid any damage to this light, please do not use any chemical or abrasive cleaner
HOW TO OPERATE AND INSTALL
HOW IT WORKS
CLEANING AND MAINTENANCE
Solar Wall Light with Sensor(2-Pack)
Model No. ELI0990V
This product contains (1)3.7V 18650 1800mAH Li-ion rechargeable battery.
When the battery expires, it must be recycled or disposed of properly. Please
contact your local waste disposal authority for correct procedure. Do not put
battery into fire.
Battery replacement
• Use a screwdriver to remove the 6 screws on the bottom of the light fixture
• Open the battery chamber cover.
• Replace the old battery with new battery making sure the polarity is correct.
• Place back the battery chamber cover by tightening the 6 screws.
RECHARGEABLE BATTERY
securit y
www.homezonesecurity.com
Solar panel collects sunlight to
charge the battery (included) during
the day
1Automatically turns on at dusk for up
to 8 hours of nighttime illumination
2
Figure 1
Figure 2
Automatically turn to bright light
at night when people walk into
the detection range
3
5 m 5 m
last 30 seconds
Automatically turn to dim light at
night when people walk out of the
detection range
4