Workrite 2-Leg Equal Corners 46″-48″Wx23″-24″D, T464623 Installation guide

Brand: Workrite

Model: 2-Leg Equal Corners 46″-48″Wx23″-24″D, T464623

Type: Installation guide

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 1500304 Rev B

Worksurface Mounting Instructions:

2-Leg Equal Corners 46"– 48" W × 23"– 24" D, T464623

Attach Base to Worksurface

If you have a Workrite Pre-Drilled

Worksurface:

1.1 Position leg assemblies to align mounting holes in brackets to pre-drilled holes in worksurface as shown below.

Attach using #12 × ¾" Pan Head Laminate Top Screws included with your frame set. Continue to follow the

frame set instructions to complete workcenter assembly.

If you have a non-Workrite Worksurface:

1.1 Position Frame Set as shown, centered le to right.

1.2 Make sure feet do not exceed rear and side edge.

Note suggested placement of Control Box, Cable Spools and Switch. Continue to follow the frame set

instructions to complete workcenter assembly.

DO NOT EXCEED

SIDE EDGE

CONTROL SWITCH

(OPTION - RIGHT)

CONTROL SWITCH

(OPTION - LEFT)

DO NOT EXCEED

SIDE EDGE

41.57

29” D Foot

Distance between brackets

Cable Spool

location

Control Box

location

29” D Foot

34.31

Reference location

for front of foot.

Reference location

for front of foot.

GRAIN DIRECTION

15° 15°

10.91

3.91

46” - 48”46” - 48”

DO NOT EXCEED

REAR EDGE

DO NOT EXCEED

REAR EDGE

23” - 24” 23” - 24”

1Note: Avoid trip or tip hazards!

For uniquely shaped, non-rectangular worksurfaces, it is the

installer's responsibility to position the worksurface to minimize

extended overhangs and position feet fully under the worksurface.

1.11.1

1.21.2

1.2 1.2

1.1

Workrite 2-Leg Equal Corners 46″-48″Wx23″-24″D, T464623 Installation guide

Workrite 2-Leg Equal Corners 46″-48″Wx23″-24″D, T464623 Installation guide

Workrite 2-Leg Equal Corners 46″-48″Wx23″-24″D, T464623 Installation guide

Related papers

Other documents