Crossbar Assembly
STEP 2
1of4
LightSourceToolsRequired
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
150W
MAX
1BULBREQUIRED
BULBNOTINCLUDED
Crossbar Assembly
x1
A
Package Contents
PARTS BAG
I
Glass Panels
& Fixture Loop
Table of
Contents
STEP 1
Fixture Chain
x1
E
Ceiling Canopy
x1
F
Quick Link
x2
D
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
Fixture Loop
x1
G
Outlet Box Screw
x2
B
Wire Connector
x3
C
Fixture Body
x1
H
Ceiling Canopy Bulb
STEP 6
Glass Panel
x4
STEP 5
Fixture Chain Wiring
STEP 4STEP 3
Warnings and Cautions
Turn off the electricity at the circuit breaker
before installation. Consult a licensed
electrician if in doubt about installation.
Turn off power to the fixture and allow the
bulbs to cool before replacing.
FixtureHeightAdjustable
26.75”to122.75”
Installation Instructions: UQL1354
www.urbanambiance.com
2of4
STEP 2
1 2 3
Step 1
Install crossbar assembly
Step2-3
Test fitting ceiling canopy to nipple
STEP 1
Slot
*Glass Panels
are varies
according to
purchased*
Tab
1 2
Install Glass Panel Install Fixture Loop
N
L
N
L
www.urbanambiance.com
3of4
STEP 3
2
Step2-3
Install Fixture Chain
1
Step 1
Adjust fixture chain length
3
Suggested Chain Length:
8’ ceiling:
9’ ceiling:
10’ ceiling:
4.25” Chain
15.25” Chain
26.25” Chain
STEP 4
1 2
Step 1
Feed the fixture wires
through the loop
N
L
N
L
N
L
*Green Ground Screw
on crossbar optional
White wire (neutral)
from outlet box
Ground wire
from Fixture
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
Supply wire from fixture
ribbed side or identified
with the Label “N”
supply wire from fixture
smooth side or identified
with the label “L”
www.urbanambiance.com
4of4
STEP 5
STEP 6
www.urbanambiance.com
/
