Comelit KAE5062A
The Comelit KAE5062A is a two-family kit that includes:
- 2x 2702W internal units
- 1x 1200 transformer
- 2x ET5002 external units
This kit is ideal for small residential buildings with two separate entrances. The external units are made of stainless steel and have a vandal-resistant rating of IK07, making them suitable for use in both indoor and outdoor locations. Each external unit has two call buttons and a built-in microphone and speaker.
The internal units are wall-mounted and have a sleek, modern design. They feature a handset, key button, and supplementary button for additional services. The 2702W internal units also have a 3-position ringtone/privacy selector, allowing you to adjust the volume of the ringtone or activate privacy mode.
Comelit KAE5062A
The Comelit KAE5062A is a two-family kit that includes:
- 2x 2702W internal units
- 1x 1200 transformer
- 2x ET5002 external units
This kit is ideal for small residential buildings with two separate entrances. The external units are made of stainless steel and have a vandal-resistant rating of IK07, making them suitable for use in both indoor and outdoor locations. Each external unit has two call buttons and a built-in microphone and speaker.
The internal units are wall-mounted and have a sleek, modern design. They feature a handset, key button, and supplementary button for additional services. The 2702W internal units also have a 3-position ringtone/privacy selector, allowing you to adjust the volume of the ringtone or activate privacy mode.
Technical manual for two-family Kit Art. KAE5062A
EN
TECHNICAL
MANUAL
2
Table of contents
Warning ............................................................................................ 2
Package Contents ........................................................................... 3
Transformer Art. 1200...................................................................... 4
Description ...............................................................................................4
External unit Art. ET5002 ................................................................ 5
Description ...............................................................................................5
Technical characteristics Art. ET5002 ....................................................6
Installation ................................................................................................7
Replacing the nameplate holders .......................................................7
Internal unit Art. 2702W................................................................... 8
Description ...............................................................................................8
Technical characteristics Art. 2702W .....................................................9
Installation ..............................................................................................10
Operating distances and standard diagram ............................... 11
Wiring diagram for standard system and 1 additional door-entry phone
connection variant .................................................................................11
Operating distancesz ............................................................................. 11
Warning
Intended use
This Comelit product was designed for use in the creation of audio and video communication systems in residential,
commercial or industrial settings and in public buildings or buildings used by the public.
Installation
All activities connected to the installation of Comelit products must be carried out by qualified technical personnel, with
careful observation of the indications provided in the Manuals / Instruction sheets supplied with those products.
Wires
Cut o the power supply before carrying out any maintenance procedures.
Use wires with a cross-section suited to the distances involved, observing the instructions provided in the system
manual.
We advise against running the system wires through the same duct as the power cables (230V or higher).
Safe usage
To ensure Comelit products are used safely:
• carefully observe the indications provided in the Manuals / Instruction sheets
• make sure the system created using Comelit products has not been tampered with / damaged.
Maintenance
Comelit products do not require maintenance aside from routine cleaning, which should be carried out in accordance
with the indications provided in the Manuals / Instruction sheets.
Any repair work must be carried out
• for the products themselves, exclusively by Comelit Group S.p.A.,
• for systems, by qualified technical personnel.
Disclaimer
Comelit Group S.p.A. does not assume any responsibility for
• any usage other than the intended use
• non-observance of the indications and warnings contained in this Manual / Instruction sheet.
Comelit Group S.p.A. nonetheless reserves the right to change the information provided in this Manual / Instruction
sheet at any time and without prior notice.
3
2702W 2702W1200
ET5002
KAE5062A
×1 ×1 ×
1
ET5002 - External unit
×2
2702W - Telephone
×1
1200 - Transformer
Package Contents
This manual includes information regarding system configuration and customisation which may be perceived as necessary by
the installer.
4
3
1
6
4
12 V~
230 V~
1.
2.
Transformer with 230V primary, 12V AC / 15 VA secondary winding for continuous use. Dimensions: 53x95x65 mm (3 DIN
modules).
1. 230 V digital input.
2. Secondary 12 V AC output.
Disconnect the power supply before carrying out any maintenance procedures.
The electrical system of the building must be fitted with an omnipolar mains switch with a contact opening
of at least 3 mm, which is capable of isolating the power supply of the device.
Place the protection back over the terminals and close the inspection door after every procedure.
Transformer Art. 1200
Description
5
1.
2
3.
4.
5.
6.
7.
10.
9.
8.
External unit Art. ET5002
Description
External unit complete with 2 call buttons, 1 wall bracket and 1 flush-mounted box.
Dimensions 95×135×26.5 mm (including wall bracket).
1. Surface-mounted wall bracket Art. ET9160. A flush-mounted box Art. ET9150 is also available.
2. Stainless steel front faceplate.
3. Faceplate fixing screw holes.
4. Speaker.
5. Call buttons.
6. Microphone.
7. Speaker.
8. Terminal block for connection:
S2 S1 Electronic call signal output
4 Negative
3 Loudspeaker input
2 Microphone output
~~* 12V AC power supply terminals
9. TM2 Microphone volume adjustment trimmer.
10. TM1 Loudspeaker volume adjustment trimmer.
6
Technical characteristics Art. ET5002
MAIN SPECIFICATIONS
Type Single-plate entrance panel
Type of finish Stainless steel front faceplate
Audio system Yes
Flush-mounted Yes
Wall-mounted Yes
Power supply 12V
Maximum current absorption (mA) 267
Clamps ~* ~ 2 3 4 S1 S2
Buttons to call Yes
Total buttons 2
Microphone volume control Yes
Loudspeaker volume control Yes
Operating temperature (°C) -25 ÷ 55
IP protection rating IP54
Vandal Resistant IK IK07
Backlighting color White
FUNCTIONS
Key button function Yes
COMPATIBILITY
Traditional system Yes
2
1
2
1
2
3
321
9,5 cm
13,5 cm
21
1
ET9160
2
CH2
2
3
1
5A4A3A
2
1
ET9150
CH2
2
3
1
5B4B3B
7
Installation
Replacing the nameplate holders
8
Internal unit Art. 2702W
Description
6.
7.
2.
1.
5.
3.
4.
8.
9.
10.
MINI series door-entry phone for traditional systems, with electronic call, handset, key button and supplementary button for
additional services. Call volume and privacy mode can be set via a 3 position selector switch; activation of privacy mode is
signalled by a red indicator.
Dimensions: 105 x 190 x 28 mm
1. Handset
2. Button P1 for additional services
3. Key button
4. 3-position ringtone / Privacy selector:
High position: Maximum ringtone volume
Middle position: Medium ringtone volume
Low position: Privacy activation (Privacy service means
exclusion of the call ringtone from the external unit and
switchboard)
5. Red indicator signaling: Privacy service active
6. Loudspeaker
7. Audio hook
Do not press and hold the audio hook
while the handset is lifted
8. Terminal block:
P2C2 Free Pushbutton C-NO
P1 Key button
4 Negative
3 Microphone output
2 Loudspeaker input
S Electronic call signal input
9. Bell / Privacy selector
10. Handset connector
9
Technical characteristics Art. 2702W
MAIN SPECIFICATIONS
Audio system Yes
Audio/video system Yes
Wall-mounted Yes
Desk base-mounted Yes
Hands-free function No
Induction loop function No
Product colour White
Total buttons 2
LED signaling (No.) No
FUNCTIONS
Actuator control function Yes
Switchboard call function No
Panic call No
Intercom function No
Selective intercom call No
Privacy function Yes
Doctor No
Floor door call function No
Electronic bell Yes
Customisable ringtone No
Key button function Yes
SETTINGS
Loudspeaker volume control Yes
Microphone volume control Yes
Ringtone volume control Yes
GENERAL INFO
Product height (inches) 7.48
Product width (inches) 4.06
Product depth (inches) 1.18
COMPATIBILITY
Traditional system Yes
TECHNICAL SPECIFICATIONS
Power supply voltage 15 ÷ 16
Microphone Ø 9,6 x 6,9 mm
Loudspeaker Ø 0,50 mm ; Max Imput Power 0,5W
IP Rating 30
Operating temperature (°C) -5 ÷ 40
Product weight (g) 0.57
Clamps S 2 3 4 P1 C2 P2
10
1
2
7
8
max 7 cm
1
1
CLACK!
2
CLACK!
1
1
1
1
2
5
4
6
2
1
3
3
3
3
2
1
3B
3C
2
1
2
3D
1
2
2
3
2
2
1
cm 160
cm 130
3A
2
1
mm 190
mm 105
Installation
11
1 mm²
1,5 mm²
1,5 mm²
200 m 200 m 80 m
0,8 mm²
1 mm²
1 mm²
150 m 150 m 30 m
0,5 mm²
0,8 mm²
0,8 mm²
50 m 50 m 10 m
Operating distances
S 2 3 4
P
1
S 2 3 4
P
1
120
0
~
S2
S1
4
3
2
~
~
*
*
2702W2702W
ET5002
12V~
230V~
1
P
2 3 4S
2702W
1
P
2 3 4S
2702W
C
2
P
2
NO C
24 C DC
100 mA
max
C
2
P
2
NO C
24 C DC
100 mA
max
C
2
P
2
NO C
24 C DC
100 mA
max
C
2
P
2
NO C
24 C DC
100 mA
max
Local lock release button.
Operating distances and standard diagram
Wiring diagram for standard system and 1 additional door-entry phone connection
variant
www.comelitgroup.com
Via Don Arrigoni, 5 - 24020 Rovetta (BG) - Italy
1
st
edition 07/2017
cod. 2G40002037
CERTIFIED MANAGEMENT SYSTEMS
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Comelit 1200 Technical Manual
- Type
- Technical Manual
Comelit KAE5062A
The Comelit KAE5062A is a two-family kit that includes:
- 2x 2702W internal units
- 1x 1200 transformer
- 2x ET5002 external units
This kit is ideal for small residential buildings with two separate entrances. The external units are made of stainless steel and have a vandal-resistant rating of IK07, making them suitable for use in both indoor and outdoor locations. Each external unit has two call buttons and a built-in microphone and speaker.
The internal units are wall-mounted and have a sleek, modern design. They feature a handset, key button, and supplementary button for additional services. The 2702W internal units also have a 3-position ringtone/privacy selector, allowing you to adjust the volume of the ringtone or activate privacy mode.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Comelit KAE5063 Technical Manual
-
Comelit 2701W / 2702W Owner's manual
-
-
-
-
-
-
-
-
