Page is loading ...
Page is loading ...
3
Important Notice
Storage and I/O Blade AD106a
This document contains important instructions for using the Storage and I/O Blade AD106a. Read carefully before
you use the system.
Keep this document for future reference.
The user's guide of this product is registered in the root folder of user's guide CD of the product attachment by the
following names. The Adobe(R) Reader(TM) is required to view or print this document.
N8404-001F_UsersGuide.pdf
Notes on Firmware Revision of EM Card
for Blade Enclosure (SIGMABLADE-M/H/H v2)
When you use following EM cards to use this Storage and I/O Blade AD106a, firmware of the EM card need to be
updated to enhance linkage function between EM card and this blade.
If the firmware of EM card is not updated, this Storage and I/O Blade AD106a cannot operate normally.
See the table below for EM card that needs update of the firmware.
N Code Firmware that needs update
N8405-019/019A Rev 4.29 or earlier
N8405-027 and the standard EM card included Rev 3.81 or earlier
in SIGMABLADE-H
N8405-043 Rev 4.29 or earlier
To update firmware of EM card, download the firmware from the following web site, or contact your service
representative.
- How to access -
1. Access download page of NEC Express5800 Server Series.
[http://www.nec.com/global/prod/express/download/index.html#c4]
2. Select [Server Options] – [EM Card [N8405-xxx]].
When you update firmware of EM card, it is not necessary to stop blade servers in the Blade Enclosure.
Errata for User’s Guide
Installing in Blade Enclosure
3-5 Installation
Added
4
Removing form Blade Enclosure
If it is difficult to push the eject lever when installing a Storage and
I/O Blade unit, please retry installation after removing the Storage and I/O Blade
unit. If it is still difficult after the retry, please contact your service representative.
Do not forcibly push the eject lever.
3-7 Removal
Added
If you feel difficult to withdraw the Storage and I/O Blade unit from the
enclosure, please push the unit and pull the eject lever.
Then the unit will be withdrawn.
/
