ASSEMBLY INSTRUCTIONS
Assembly of Headrest AQUATEC BELUGA
Updated: 01.01.02/Marketing Page 1 of 2 V/Allgemein/Montage/Montageanleitungen/
Deutsch/Beluga/Montage Kopfstütze
16126 Assembly headrest Beluga
Please read the entire assembly instructions carefully before beginning the assembly!
1. DELIVERY ITEMS:
Headrest AQUATEC FORTUNA / BELUGA, white Order no. 15461
Consisting of:
4 Mountings (plastic part) Part 1 Order no. 15407
4 Flat-headed screws size Ø 4 x 20 (VA) Part 2 Order no. 13091
1 Bracket – round steel Ø 8 (VA) Part 3 Order no. 15446
1 Cover – woven mat with Velcro fastener Part 4 Order no: 15466
2. PREPARATION:
For backrest with existing assembly drill holes for mounting the headrest
(4 holes for flat-headed screws and 4 holes for fixing pegs).
1.) have a cross-tip screwdriver size 2 available
2.) unbutton the backrest cover
For backrest without assembly drill holes carry out preparations as described above.
Additional tools required: Suitable electric drill (or battery powered drill), countersink 10x90°, twist
drills Ø 4.2 and Ø 5,1 mm.
3. WORK STEPS:
1. In accordance with the diagram below drill the 4 centres marked with (a) with a Ø 4.2 mm
twist drill.
2. In accordance with the diagram below drill the 4 centres marked with (b) with a Ø 5.1 mm
twist drill.
3. Countersink the 4 holes with Ø 4.2 mm (pos. a) with the countersink on the front side
(cover side) to Ø 8.5 mm (suitable for screw 4 x 20).
4. Deburr the other drill hole edges on both sides with the countersink.
4 x Part 1 + 2
Part 3
Part 4
ASSEMBLY INSTRUCTIONS
Assembly of Headrest AQUATEC BELUGA
Updated: 01.01.02/Marketing Page 2 of 2 V/Allgemein/Montage/Montageanleitungen/
Deutsch/Beluga/Montage Kopfstütze
16126 Assembly headrest Beluga
4. WORK SAFETY:
It is imperative that you observe the accident prevention regulations of the tools and machines
used. In drilling the backrest take care not to injure your fingers. Use an underlay when drilling,
e.g. an old wooden board. Make sure the twist drill is at right angles to the surface.
Drilling diagram:
5. ASSEMBLY:
1. Screw the mountings (part 1) to the back of the backrest with the flat-headed screws (see
picture 1 below).
2. Button on the backrest cover again.
3. If not already pre-assembled, pull the headrest cover (part 4) over the bracket (part 3) and
fasten with Velcro fastener.
4. Insert the bracket (part 3) into the screwed on mountings. (Assembly completed).
The height adjustment of the headrest to correspond to the size of the person is done by pulling
up or pressing down the bracket complete with cover (parts 3 and 4) in the mountings (part 1).
Picture 1 (from above)
/