Revolabs IP 7000 User manual

Revolabs
Brand
Revolabs
Model
IP 7000
Category
Speakerphones
Type
User manual

This manual is also suitable for

Revolabs Single Channel System - Polycom IP 7000 Setup Guide
NOTES A ND CAUTIONS:
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom IP 7000 speakerphone.
1. Connecting the Cables
2. Configuring the IP 7000 speakerphone
The Cisco 7937G is a variant of the Polycom IP 7000 and has the same programming
instructions.
Note:
It is important to carefully follow these instructions in order and completely .
Otherwise your Single Channel System and/or the phone may not function properly.
Please read through these instructions completely before proceeding. Contact Revolabs
technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Polycom IP 7000 speakerphone
3. Polycom SoundStation IP Multi Interface Module (P/N 2200-19300-001)
Connecting the Cables
CONNECTING A REVOLABS SINGLE CHANNEL TO THE POLYCOM IP 7000 SPEA KERPHONE
1. Connect the Single Channel System to the SoundStation IP 7000 the left “Audio
In” port on the Multi Interface Module using the Revolabs 2.5mm to RCA cable
Configuring the IP 7000 Speakerphone
CONFIGURING THE A UDIO MENUS OF THE IP 7000 SPEAKERPHONE
1. Press the MENU button
2. Scroll down to SETTINGS (3)
3. Select BASIC (1)
4. Scroll down to AUDIO (5)
5. Select AUXILIARY AUDIO (2)
6. Select AUX AUDIO IN (1)
7. Verify that OTHER INPUT (2) is active
  • Page 1 1
  • Page 2 2
  • Page 3 3

Revolabs IP 7000 User manual

Revolabs
Brand
Revolabs
Model
IP 7000
Category
Speakerphones
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents