Refrigerator Handle Kit Installation Instructions
Page 3
Top Handle Installation
STEP 7: Mount the handle to the top door
by sliding the holes on the back
over the handle mounting studs on
the right door. Make sure the set
screw holes face away from the
center of the refrigerator. Loosen
the set screws if necessary to al-
low the handle to slide into place.
STEP 8: Carefully tighten the set screws
into place using the 3/32” Allen
wrench. Be careful not to scratch
thenish.
STEP 9: Check to make sure the handle is
rmlyattached.
Handle Mounting
Studs
Set Screw
Holes
NOTE: Refrigerator with right
door swing shown. On models
with hinges on left, mount the
handle to the opposite side.