Electrolux EDD210 LH User manual

Brand: Electrolux

Model: EDD210 LH

Category: Electric laundry dryers

Type: User manual

This manual is also suitable for

Electrolux EDD210 LH is a versatile appliance designed to efficiently dry clothes, shoes, and other items. Its key capabilities include:

Gentle Drying: The device utilizes a low-temperature drying process to prevent damage to delicate fabrics and extend the lifespan of your clothes.
Adjustable Temperature Settings: With adjustable temperature settings ranging from 30 to 70 degrees Celsius, you can customize the drying process based on the specific requirements of different fabrics.
Timed Drying: The built-in timer allows you to set the drying duration, ensuring that your clothes are dried to the desired level of dryness without over-drying.

Electrolux EDD210 LH is a versatile appliance designed to efficiently dry clothes, shoes, and other items. Its key capabilities include:

Gentle Drying: The device utilizes a low-temperature drying process to prevent damage to delicate fabrics and extend the lifespan of your clothes.
Adjustable Temperature Settings: With adjustable temperature settings ranging from 30 to 70 degrees Celsius, you can customize the drying process based on the specific requirements of different fabrics.
Timed Drying: The built-in timer allows you to set the drying duration, ensuring that your clothes are dried to the desired level of dryness without over-drying.

Page is loading ...

TECHNICAL DATA

SAFETY INFORMATION

You should read all of these instructions before starting to use the dryer.

The dryer should only be used by persons who have read and understood

the contents of this publication, and who can be expected to comply with the

instructions, including the safety information.

• The appliance must be connected to an electrical supply which is earthed.

If the appliance is to have fixed wiring to the electrical supply, this work

may only be carried out by a qualified electrician.

• The appliance must be secured to the wall behind it, to prevent it from tip-

ping forward. Failure to secure it in this way will invalidate the guarantee.

• The room or area in which the appliance is installed must be suitably venti-

lated.

• The appliance is designed from the evaporation of water only.

• Laundry and other items which have been in contact with volatile solvents

(dry-cleaning fluid, stain-removing solvents etc.) must not be dried in this

appliance, on account of the risk of fire.

• Before any servicing or other work is undertaken on the appliance it must

first be fully isolated from the electrical supply, either by removing the

electrical plug from the socket, or taking the appropriate action if it has

fixed wiring.

IDENTIFICATION OF PARTS

INSTALLATION

• Position the dryer in the place where it is to be installed. Adjust the feet to

ensure the dryer is level (horizontally and vertically). Check the level

using a spirit level. See Fig. 1.

N.B. Important so that the door will tighten against the cupboard.

• Use the wall-plugs, washers and screws supplied to secure the dryer to the

wall. The dryer needs to be in its permanent installation site when you are

drilling and securing it to the wall. See Figs. 1 and 2.

• The vent hose connector and exhaust vent hose should connected to an

existing ventilation system as shown in Figs. 1 and 7. In some cases it

may be difficult to ensure an adequate exhaust air flow to remove moistu-

re as required, in account of restricted space, poor existing ventilation and

so on. In these cases the dryer should be connected to the ventilation

system without using the special air terminal fitting (designed to ensure a

flow of air from the room, independent of the dryer) shown at No. 2 in Fig

1. For this alternative, follow Fig. 8: move the valve from the room venti-

lation system to inside the top of the dryer and connect the exhaust vent

hose directly to the ventilation duct using a spigot connection sleeve. A

spigot connection sleeve is not supplied with the appliance on account of

variation in the required dimensions. In installations of this type the air in-

take on the top of the dryer must not under any circumstances be cove-

red, because the ventilation of the room will now be provided via the dry-

er.

• Install the relevant control knobs on their rods on the front of the dryer.

See Fig. 1.

• Install the dryer racks as shown in Fig. 5, and press them firmly home in

their holders. The racks can be lowered when required, by lifting them

straight up out of their holders and folding them down against the back

wall. See Fig. 5.

• Connect the dryer to an earthed electrical socket.

• To change the side from which the door opens you have to change over

the door hinges and fittings diagonally. See Fig. 6.

ADVICE ON USING THE DRYER

• All types of washing, wet clothes, shoes and equipment can be dried just

as gently as required in a cabinet dryer.

• The load should be hung up to dry in a way which allows air to circulate ef-

ficiently. Items should be distributed evenly throughout the dryer. See Fig.

• Do not overload the dryer racks. Use more than one arm on the racks to

support heavy items.

• The temperature used must not be too high for the specific load. Garment

care labels may provide useful information on suitable temperatures.

To be dried at ”normal” temperature 70°C

To be dried at ”low” temperature no more than 50°C

Guidelines in the absence of labelling:

Cotton and linen 70°C

Synthetics, wool, silk 30 – 50°C

• When drying shoes or boots, the base of the dryer can be protected with

newspaper or equivalent, which can be discarded later.

Using a cabinet dryer allows you to control not only the drying time and

temperature, but also the level of energy consumption. The dryer has a

built-in thermostat and timer. The temperature control knob has a range of

0 – 70°C, and the timer can be set for up to 4 hours. The dryer is started

and stopped by means of the timer control. See Fig. 1.

From the point of view of energy conservation, longer drying times (at lower

temperatures) are preferable.

The most economical option for drying is to hang the load inside the dryer

and leave the door in its airing position, without either the fan or the heating

switched on.

Another economy option is to set the temperature control at 0°C, put the

door in airing position, and operate the fan only.

For the door airing position, see Fig. 4.

Guideline drying times and energy consumption figures are shown in the ta-

ble below.

The figures quoted are for a 3 kilogram load (weight when dry) which has

been spun at 900 rpm (70% of moisture remaining). Wash loads which have

been spun at speeds higher than this and with less moisture remaining requi-

re less drying time and less energy to dry.

In houses with mechanical ventilation systems there is frequently the option

of accelerating the total exhaust air flow from the dwelling. If experience

shows that the air humidity is frequently too high when the dryer is in use,

this humidity can be reduced significantly if the air flow is accelerated at the

start of the drying time.

CARE

Use only water and a soap solution for cleaning the dryer.

Important: Never use volatile solvents.

If water accumulates inside the base of the dryer it should be removed with

a sponge or cloth. The base of the dryer should be kept as clean as possible

at all times. It will generally be dry, in which case it can be cleaned with a

vacuum cleaner.

FAULT-TRACING

If the fan fails to operate, check:

— that the timer is on

— that the electrical plug is in the socket and switched on

— that no fuses have blown

— that the thermal cutout has not tripped (see the section the

thermal cutout).

If the dryer is not heating, check:

— that the temperature control is set at the required temperature

Thermal cutout. If this is tripped, both the fan motor and the heating ele-

ments will cut out.

To restart the dryer, turn the timer control to ”0”, then after about five minu-

tes turn it to the required drying time.

Always investigate why the thermal cutout has tripped, and rectify the pro-

blem if you can. Two possible causes are that the air intake on the top of

the dryer has become blocked or covered, or that the dryer load has been

hung up in a way which prevents adequate circulation of air.

SERVICE

If you cannot identify the cause of or rectify a malfunction, contact

the service company authorised by the machine’s supplier.

Use only genuine spare parts.

Before contacting the service company, make a note of the machi-

ne model, product number and serial number. This information can

be found on the data plate inside the dryer.

1. Exhaust air valve

2. Air terminal fitting (for ventilating

room)

3. Exhaust vent hose

4. Cable straps

5. Control for setting temperature

6. Control for setting time

7. Plastic wall-plug

8. Washer

9. Screw

10.Dryer rack

11. Adjustable foot

12. Removable plinth panel

13. Hinge

14. Vent hose connector

15. Spigot connection sleeve

16. Ventilation duct

Height: ............................. 1 850 mm

Width: ................................. 600 mm

Depth: ................................. 600 mm

Weight: ....................................55 kg

Supply voltage: ...................... 230 V

Fuse: ........................................ 10 A

IP classification: ..................... IP 24

Temp. selector:............... 30 – 70 ºC

Timer control: ...................... 4 hours

Power consumpt., heat: ..... 2 000 W

Power consumpt., motor:........ 35 W

Total power consumpt.: ...... 2 035 W

Tot. length of drying space:.... 18 m

Load capacity: ..... 5 kg (dry weight)

Temperature set, (°C) Power consumption, (Watt) Drying time, (hours) Energy consumption, (kWh)

0 0 (door in airing position) 10 0

0 35 W (door in airing position) 8 0,16 (fan 4 hours)

50° 2 035 W 1,6 2,8

70° 2 035 W 1,4 2,8

Page is loading ...

Electrolux EDD210 LH User manual

Brand: Electrolux

Model: EDD210 LH

Category: Electric laundry dryers

Type: User manual

This manual is also suitable for

Electrolux EDD210 LH is a versatile appliance designed to efficiently dry clothes, shoes, and other items. Its key capabilities include:

Gentle Drying: The device utilizes a low-temperature drying process to prevent damage to delicate fabrics and extend the lifespan of your clothes.
Adjustable Temperature Settings: With adjustable temperature settings ranging from 30 to 70 degrees Celsius, you can customize the drying process based on the specific requirements of different fabrics.
Timed Drying: The built-in timer allows you to set the drying duration, ensuring that your clothes are dried to the desired level of dryness without over-drying.

Download PDF

report

in other languages

Deutsch: Electrolux EDD210 LH Benutzerhandbuch
svenska: Electrolux EDD210 LH Användarmanual

Electrolux EDD210 LH User manual

This manual is also suitable for

Electrolux EDD210 LH User manual

in other languages

Related papers

Other documents