1
Installation Instructions for
Temporarily install the mounting plate to the junction box and mark the anchor hole locations through the mounting plate
holes. Remove the mounting plate.
Drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Place the shade onto the socket and secure it place by screwing the collar nut onto the socket using the provided shade tool.
Repeat for remaining shades.
Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage information.
1
2
3
4
5
Ansely Wall
1.0
VS2451-VS2452-VS2453-VS2454
VS2451, VS2452, VS2453, VS2454
Wall
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
This product can be dimmed using a low-voltage electronic dimmer.
This instruction shows a typical installation.
OL
1A
JUNCTION BOX
MOUNTING PLATE
SOCKET
6
7
8
9
10
FIXTURE SCREW
ANCHOR
SHADE TOOL
7
6
SHADE
COLLAR NUT
LAMP
10
ANCHOR
SCREW
9
2 4
