1
Installation Instructions for
For Models OL15101, OL15103, and OL15105 Only: Temporarily install the mounting plate to the junction box and mark the
anchor hole locations through the mounting plate holes. Remove the mounting plate.
For Models OL15101, OL15103, and OL15105 Only: Drill appropriate sized holes at the marked locations and install the
anchors.
Secure the mounting plate to the junction box.
For Models OL15101, OL15103, and OL15105 Only: Screw the anchor screws into the anchors.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
For wet locations, caulk around the base of the fixture using waterproof construction sealant.
1
2
3
4
5
Milton Outdoor Wall
1.0
OL15100-OL15101-OL15103-OL15105-L1
OL15100, OL15101, OL15103, OL15105-L1
Outdoor
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for wet locations.
This product can be dimmed using a low-voltage electronic dimmer.
This instruction shows a typical installation.
8
9
OL
1A
JUNCTION BOX
MOUNTING PLATE
FIXTURE
6
7
8
9
2
4
FIXTURE SCREW
ANCHOR
ANCHOR SCREW
3