Legrand 19" Insert Interface Plate, 16 opening, IS-0122 Installation guide

IS-0207 Rev. O Page 1 of 1

Installation/Instruction Sheet

19” Insert Interface Plate,

16 Opening

IS-0207 Rev O

OnQ Technologies, Inc.

P.O. Box 60907

Harrisburg, PA 17106-0907

800-321-2343

www.onqtech.com

1. Introduction

The 19” Insert Interface Plate, 16 Opening, P/N 364576-01 provides a convenient structured interconnect for

mounting OnQ AnyPort application inserts within a standard 19” Racking System. This plate will provide a

convenient way to mix the termination of coax and UTP cable in a single panel.

2. Description

The 19” Insert Interface Plate, 16 Opening, is a 1 U (1.75 inch tall) rack product that mounts to a standard 19”

Rack System. The Insert Interface Plate is black powder coated steel (see Figure 1).

3. Installation

A. Mounting into a standard 19” Racking System (see Figure 2)

1. Select the location within the rack to allow easy

access of the input and output connections.

2. Align the mounting holes to the tapped holes in the

rack rails.

3. Assemble the 19” Insert Interface Plate to the rack

rails using the (4) #10-32 x .38 Pan Head Screws

provided.

B. Cable connections

1. Select desired combination of OnQ AnyPort Inserts.

2. Terminate cable per insert instructions.

3. Install inserts in panel. Inserts install as outlined in instruction for mounting to faceplate.

4. Dress and secure cables.

Figure 2

Figure 1