Aquaterior 2020 Upgraded Double Handle Brass Pre-Rinse Commercial Faucet Chrome User manual

Brand
Aquaterior
Model
2020 Upgraded Double Handle Brass Pre-Rinse Commercial Faucet Chrome
Category
Sanitary ware
Type
User manual

This manual is also suitable for

Commercial Faucet
User’s Manual
20
Please read this user manual thoroughly before installation and use.
Keep this user manual for future reference.
For more information about our products, please visit:
www.aquaterior.com
CAUTION
Always turn off the main water supply before removing or
disassembling the faucet and open the faucet handle to ensure that
the water pressure is completely relieved.
Cautions
1. Before carrying out the installation, please thoroughly read this
manual. Keep this user manual for future reference.
2. Before carrying out the installation, ensure the water supply that
this produce is connected to is turned off first.
3. Do not install this product under sunlight directly.
4. Wrap all the connection parts with Teflon tape and plumber’s
putty if needed to avoid water leakage and ensure them are
connected securely.
5. Keep the parts of this product away from children to avoid risk of
choking.
6. The installation of this product should be carried out by
professionals with sufficient related experience and knowledge.
7. Don’t use corrosive detergent to clean this product.
8. Check at regular intervals to ensure that the installation is not
leaking.
9. Always switch off the main water supply when disassemble the
faucet
Clean the surface of the product with a piece of cloth and
non-abrasive faucet specialized cleaner at regular intervals.
Troubleshooting Table
Issue(s)
Possible Cause(s)
Solution(s)
Leakage
Missing Gaskets.
Reinstall Gaskets.
Gaskets are broken.
Replace the broken gaskets.
The connection is
not tightened up
1. Ensure the connections
are tightened securely.
2. Use plumber’s putty and
teflon tape to seal up
the leakage.
2
19
Sprayer x 1
Package Contents
Riser Pipe x 1
Wall Bracket x 1
Sprayer Hook x 1
Lever Handle x 1
Tube x 1
Screw x 2
Screw Sleeve x 2
Iron Ring x 1
Allen Key x 1
About the Iron Ring
Bind up the valve switch with the iron ring to let the water come out the
sprayer continuously.
Cleaning the Faucet Aerator
Loosen out the faucet aerator from faucet and clean it regularly.
3
18
Faucet Head x 1
Faucet Handle x 1
Specifications
Suitable Water Pressure
0.05 to 3 MPa
Suitable Water Temperature
0 ℃ to 100 ℃(32 ℉ to 212 ℉)
Flow Quantity
11.12 L/min to 12.98L/min
(0.3 MPA/60S to 0.42 MPA/60S)
Tools Required (Not Included)
Philips Screwdriver
Adjustable Wrench
Plumber’s Putty
Teflon Tape
13
Install the sprayer onto the riser pipe. Hang the sprayer head onto the
sprayer hook. The installation is finished. Remember to switch the main
water supply back on.
4
17
Gasket A x 1
(Spare)
Gasket B x 3
(Spare)
Gasket C x 1
(Spare)
Gasket D x 1
(Spare)
Gasket E x 2
(Spare)
Gasket F x 1
(Spare)
Fastening Screw x 2
(Spare)
Rough-in Drawing
12
Thread the iron ring through the sprayer.
Φ 1 1/2” (38mm)
16”
(408mm)
17 5/8”
(448mm)
12”
(305mm)
G 1/2”
8 3/8”
(212mm)
7 3/16”
(196mm)
Gasket A
Gasket D
Gasket C
Gasket F
Gasket E&B
Gasket E&B
5
16
Threaded pipes are not included.
47 1/8”
(1120mm)
11
Fix the wall bracket on the wall with screws and screw sleeves. Fasten
the other side of wall bracket on the riser pipe. Fasten the sprayer hook
as well.
Screw Sleeve
Screw
25”
(640mm)
38”
(965mm)
20”
(508mm)
Φ 10/16” (16mm)
13”
(328mm)
9 9/16”
(243mm)
3 3/8” (88mm)
3”
(80mm)
Φ 10/16” (16mm)
6
15
7/8-20UN
3/8-18NPT
Installation Instructions
Note:
1. The rubber gaskets and rubber rings have already been preinstalled
in their corresponding locations, except for the ones mentioned in
the following steps. It is not necessary to install them again. The ones
in the plastic package are for spare use.
2. Switch off the main water supply first before installation.
Loosen the pipe connectors from the lever handle.
Pipe Connector
1
10
Connect the faucet head and riser pipe to the faucet handle.
7
14
2
The gasket B and E have already been put in the pipe connectors.
Before the next installation step, ensure that they are in their
corresponding locations.
Gasket E
Gasket B
3
Insert the threaded pipes (not included) into the holes of the
connectors. The threaded pipes are not included in this product.
Customer needs to buy it separately.
Threaded Pipe (1/2”)
9
Thread the riser pipe through the sprayer hook and wall bracket.
8
13
Hot Water Supply
Cold Water Supply
4
Insert the other ends of the threaded pipes into the hot water supply
and cold water supply.
8
Connect the two parts together. Secure the connection by fastening
the cover nut back to the lever handle.
9
12
5
Install the lever handle back to the pipe connectors. Fasten the
connection with a wrench.
6
Loosen the cover nut from the lever handle.
7
Cover Nut
Connect the faucet handle, cover nut (taken out from the lever handle
in the preceding step) and tube together.
10
11
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

Aquaterior 2020 Upgraded Double Handle Brass Pre-Rinse Commercial Faucet Chrome User manual

Brand
Aquaterior
Model
2020 Upgraded Double Handle Brass Pre-Rinse Commercial Faucet Chrome
Category
Sanitary ware
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents