2. Toro
  3. Replacement Pulley Kit, Z593-D Z Master Models 74264TE and 74265TE

Toro Replacement Pulley Kit, Z593-D Z Master Models 74264TE and 74265TE, Replacement Pulley Kit, Z593-D Z Master Models 74264 and 74265 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro Replacement Pulley Kit, Z593-D Z Master Models 74264TE and 74265TE Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Form No. 3355-106 Rev A
Replacement Pulley Kit
For Z593-D Z Master® Models 74264, 74264TE, 74265
and 74265TE
Model No. 110-3944
Model No. 110-3945
Installation Instructions
T his kit is for installing a DFS bag g er onto a
Z593–D Z Master .
Note: Before remo ving the pulley , mak e sure the g earbo x dri v e pulley does not ha v e 4 holes around
the center hole .
Step
1
Replacing the Gearbox Drive
Pulley
Parts needed for this step:
1
Pulley
1
Square key
2 Set screw
Procedure
1. R emo v e the mo w er belt from the g earbo x
pulley assembly ( Figure 1 ).
2. R emo v e the 2 set screws , square k ey , and
g earbo x pulley from the g earbo x.
3. Install the bag g er dri v e pulley to the new
g earbo x pulley with 3 bolts (3/8 x 1-3/4
inc hes), 3 spacers , and 3 flang e n uts (3/8 inc h)
( Figure 1 ). T his hardw are is supplied with the
bag g er .
4. Install the g earbo x pulley and bag g er dri v e
pulley to the g earbo x with 2 set screws and a
square k ey ( Figure 1 ). T he pulley center hub
needs to be flush with the end of the g earbo x
shaft.
5. Install the mo w er belt bac k onto the g earbo x
pulley ( Figure 1 ).
Figure 1
1. Gearbox
5. Spacer
2. Flange nut, 3/8 inch 6. Bagger drive pulley
3. Gearbox drive pulley 7. Bolt, 1/2 x 1-3/4 inch
4. Set screw
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved
/