2. Blue Hawk
  3. 55432

Blue Hawk 55432 User manual

  • Hello! I am an AI chatbot trained to assist you with the Blue Hawk 55432 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ITEM/ARTICLE/ARTÍCULO #0267939
MODEL/MODÈLE/MODELO #55432
36 IN. ADJUSTABLE CLAMP RAIL
PACKAGE CONTENTS/
HARDWARE CONTENTS/
SAFETY INFORMATION/
Rail
x1
Screw
x 3
Hooks
x8
End Cap
x2
WARNING: Read and understand all instructions before beginning installation. Failure to follow all instructions may result in serious personal injury.
• Do not mount to hollow dry wall. Mount only to wall studs or concrete.
• Do not mount to ceiling.
• Wear safety glasses during assembly.
• Holds 10 lbs. per hook when the rail is securely mounted to wall studs or concrete.
PREPARATION/
Before beginning installation of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is
missing or damaged, do not attempt to assemble, install or operate the product.
A
B
C
AB14520
Note: Hardware shown actual size.
Estimated Installation Time: 10 minutes/
Tools Required for Assembly (not included): Power drill with Phillips drill bit or Phillips screwdriver, pencil, stud finder, tape measure and a level.
AA
MOUNTING INSTRUCTIONS/
OPERATING INSTRUCTIONS/
OPERATING INSTRUCTIONS/
From time to time, check all hardware to make certain it is still fully tightened.
1
2
1&2
3
WARNING: If mounting over drywall, you must mount to the wall studs behind.
1.Locate wall studs with a stud finder and mark the location with a pencil. Make sure the hooks
(B) and rail (A) are in the correct upright position. When holding the rail (A) against a wall, the
hook (B) arms should be perpendicular to the rail (A). Slide hooks (B) along the rail (A) to make
all three mounting holes visible.
1.To hang an object, raise the hooks (B) up and set the object in place. Gravity will force the hooks
(B) back together and hold the object.
2.To remove an object, raise it so the hooks (B) separate and remove the object.
3.To remove a hook (B) from the rail (A), first remove an end cap (C) by unscrewing it. Slide the
hook (B) off the rail (A) and replace the end cap (C).
2.Place the rail (A) at desired height, aligning it with the studs, and loosely screw in one end using
screw (AA). Level the rail (A) and screw (AA) in other end. Once you are sure it is level, insert
the remaining middle screw (AA) and tighten all screw (AA) fully. Finally add to end cap (C).
/