Continental Industries 5161-24-0717-00 Installation guide

The Ultimate Connection

Continental

Continental Industries, Inc. Tel. 800.558.1373 www.conind.com

4102 S 74th East Ave Tel. 918.627.5210 www.thermoweld.com

Tulsa, OK 74145 USA Fax. 918.622.1275 [email protected]

GAS • PROPANE • PLUMBING • WATER DISTRIBUTION • CATHODIC PROTECTION

34-4834-49

FASTTAP®

OPERATING INSTRUCTIONS FOR FASTTAPS WITH BAND STRAPS

1. CLEAN MAIN OF ALL DIRT AND DEBRIS IN THE AREA WHERE THE SADDLE IS TO BE MOUNTED. PAY

PARTICULAR ATTENTION TO THE AREA WHERE THE GASKET WILL MAKE ITS SEAL.

2. BACK OFF NUT ON BANDSTRAP STUD UNTIL IT IS FLUSH WITH END OF STUD.

3. PLACE BANDSTRAP AROUND MAIN IN THE DESIRED POSITION. PLACE STUD BETWEEN STRIP ON

OPPOSITE END OF BANDSTRAP. TIGHTEN UNTIL LEAK TIGHT.

4. CUT PIPE ENDS SQUARE, DEBURR OUTSIDE AND INSIDE, CLEAN THOROUGHLY TO ASSURE THERE IS NO DIRT,

GREASE, OIL, ETC. ON ASSEMBLY AREA OF PIPE.

5. CONNECT SERVICE LINE. IF OUTLET IS SOLVENT WELD OR THREADED, FOLLOW YOUR COMPANIES

PROCEDURES. IMPORTANT - ON COMPRESSION TYPE OUTLETS, TIGHTEN COMPRESSION NUT ALL

THE WAY TO SHOULDER OF OUTLET.

6. REMOVE O-RING AND CAP, THEN INSERT DRIVE KEY (33-2940-00) INTO PUNCH. GUIDE BUSHING SHOULD BE

SEATED IN TOP OF SADDLE AFTER BEGINNING TAP.

7. SCREW PUNCH DOWN UNTIL STOP ON DRIVE KEY CONTACTS THE TOP OF THE TEE. (THE TAP IS NOW

COMPLETE)

8. TO ALLOW FLOW THRU THE SERVICE, BACK PUNCH UP UNTIL THE TOP OF THE PUNCH IS FLUSH WITH TOP

OF TEE. IT IS IMPORTANT THAT THE PUNCH DOES NOT PROTRUDE ABOVE THE TEE.

9. REPLACE ORING AND CAP. SCREW DOWN 1/4 TURN PAST HAND TIGHT OR 2025 FOOT POUNDS.

ECN 2147 REV "A" 5/10/07

This manual is also suitable for

Download PDF