Peerless DCT500 Datasheet

Peerless
Brand
Peerless
Model
DCT500
Category
Wall & ceiling mounts accessories
Type
Datasheet
T E C H N I C A L D A T A S H E E T
Solid Solutions - Solid Support
Peerless Industries, Inc. 1980 Hawthorne Ave. Melrose Park, IL 60160
708-865-8870 800-865-2112 Fax 708-865-2941 www.peerlessindustries.com
page 1 of 1
A R C H I T E C T S S P E C I F I C A T I O N S
The I-beam clamp with decoupler shall be a Peerless model DCT500 and shall be mounted where indicated on the plans. It shall consist of
a I-beam clamp with an integral decoupler assembly to relieve stress (caused by side to side or swaying action that may result from minor
impacts) from damaging TVs/monitors.It shall feature a 5” (127 mm) adjustment range and a clamping I-beam interface. It shall be con-
structed primarily of 12 gage cold rolled steel and finished in black fused epoxy. It shall be UL listed. Assembly and installation shall be
done according to the instructions provided by the manufacturer.
Model: DCT500
Issued: 05-11-99 Sheet No. 128-9517-2 02-20-02
Heavy Duty I-Beam Clamp
with Decoupler
The Heavy Duty I-Beam Clamp with Decoupler is designed to anchor a
Peerless Multi-Display System to an overhead I-beam. The stub fitting
is compatible with Peerless (ADD model) Adjustable Length Extension
Columns. The built in decoupler absorbs structural vibrations.
Features:
● Adjustable Clamping I-beam interface
● Decoupler
● Scratch-resistant black fused epoxy finish
Important:
Architect or installer must verify that the I-beam will safely support
the combined load of all attached hardware and components.
*Shipping weight based on single unit shipment. Per unit shipping weight may be less for bulk orders.
**Combined weight of all atached hardware and components.
I-Beam Clamp with Decoupler
Weight
9.2 lbs.
(4.2 kg)
*Shipping
Weight
9.4 lbs.
(4.3 kg)
MIN MAX
7” 12”
(178 mm) (304 mm)
MIN MAX
.25” 1”
(6 mm) (25 mm)
AB
I-BEAM CROSS-SECTION
ISOMETRIC VIEW
DECOUPLER
STUB
SIDE VIEW
**Maximum
Load
600 lbs.
(272 kg)
B
A
WARNING: If multi-display system, in
combination with components exceeds
600 lbs. (272 kg) it therefore exceeds the
maximum load. Heavy Duty I-Beam Clamp
with Decoupler will not safely support a
combined load which exceeds 600 lbs.
(272 kg)!
5.375”
© 2002 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
This product must be
installed by a qualified,
professional installer.
R
  • Page 1 1

Peerless DCT500 Datasheet

Peerless
Brand
Peerless
Model
DCT500
Category
Wall & ceiling mounts accessories
Type
Datasheet
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents