Anova BRP300FA Installation guide

Brand: Anova

Model: BRP300FA

Type: Installation guide

TOOLS NEEDED: HARDWARE NEEDED:

Installation Instructions

Step-by-Step Installation Sequence

Hammer DrillHammer

Pencil

9/16"Wrench

Wire Brush

Level

Safety Glasses

800.231.1327

[email protected]

Ultra BRP and SBRP Bike Racks

Optional: (4 or 6) 3/8"

Rubber Washers

90130A050

(4 or 6) 3/8" x 5" 18-8

Stainless Steel Stud Anchors

92188A203

Masonry Drill Bit Set

3/16", and 3/8"

Product requires assembly before installation.

Examine the footing or slab for damage or defects. The footing or slab should be reinforced concrete rated at a

3,000 psi minimum and be cured for at least 28 days prior to the installation of the bike rack.

CAUTION: Oversized holes and holes drilled too deep in the concrete will make it dicult to set the anchor.

Installation Instructions

Step-by-Step Installation Sequence

Evacuate debris from mounting holes using compressed air and a steel wire

brush. This will create a clean environment for the anchor system.

Locate an anchor and adjust the nut so it is ush with the top of the anchor to

protect the threads from being damaged. Insert the anchor into the hole.

Use the hammer to x the anchor into the drilled hole by giving it several

hammer blows.

Repeat steps 3 - 6 until all anchors are installed.

Care should be given to avoid rubbing the nish o the foot. A 3/8" rubber

washer is a suitable replacement option. Mount the bike rack to the ground by

placing a washer and a nut onto each anchor. Leave the hardware nger tight

until all of them have been installed. Verify that the bike rack is level before

tightening the anchors. Tighten all of the hardware with a 9/16" wrench.

Remove the nuts and washers o of the anchors. Align the mounting holes of

the bike rack over top of the anchors and slide it down into place.

It is recommended that you start holes in sequential order from the

smaller to the larger drill bits to avoid oversized holes or holes drilled too

deep. Begin with 3/16" diameter drill bit followed by the 3/8" diameter bit.

Place the bike rack in the desired location. Mark the location of the holes with

a pencil. To verify the alignment of the anchor markings you may reference

page 3.

8.28.1

Ultra BRP and SBRP Bike Racks

Installation Instructions

FOOT MOUNT SIZE CHART

SKU # Width Length

BRP101

BRP101E

BRP102

BRP102E

BRP121

BRP122

BRP300 X 74.375"

BRP300FA X 74.375"

BRP300E

SBRP300 X 74.375"

SBRP300E

Width (If four points)

Length

Ø.50" (2 OR 4 PLCS)

Ultra BRP and SBRP Bike Racks

Manufactured in the U.S.

Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.

Anova BRP300FA Installation guide

Anova BRP300FA Installation guide

Anova BRP300FA Installation guide

Related papers

Other documents