2. Mountain Buggy
  3. Terrain
Terrain

Mountain Buggy Terrain, Urban Jungle Designer, urban jungle/terrain travel system Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Mountain Buggy Terrain Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
mountain
buggy
®
life without limit
WARNINGS
Check you have the correct travel system for your carseat.
WARNINGS
Do not use this travel system until you have read and understood the
instructions!
WARNINGS
Never leave your child unattended.
WARNINGS
Do not use accessories not designed for your buggy as they may be unsafe.
WARNINGS
Do not leave your baby in carseat (on or off buggy) for long periods of time.
installation instructions
urban jungle
™
/ terrain
™
Graco Snugride
™
/ Snugide32
™
travel system
Installation instructions for the travel system that fits
the Snugride
™
/ Snugide32™ infant carseat by Graco
™.
graco_bi_28-07-10.indd 1 29/07/2010 12:49:57 p.m.
IMPORTANT CHECKS
• Makesurebabyisharnessedintocarseatusingthemanufacturer’s
instructions.
• Whenttingcarseatontotravelsystem,ALWAYSkeepasteady
handoncarseatandbaby,untiltravelsystemstrapissecurelyfastened.
• Checktravelsystemisengagedcorrectlyontobuggyframeand
cannot move in any direction. (Refer back to installation instructions
to ensure positioning of snap locks are correct).
• Donotusetravelsystemifyouareunabletosecurecarseatortravel
system.Inthiscase,contactyourstore/distributorwherethebuggy
waspurchasedfrom,formorehelp.
• Itisrecommendedthatyoupractisethefollowinginstructionswithout
baby in carseat.
1. Remove sunhood.
2. Unfasten domes on both sides of
buggy and peel fabric back exposing frame.
Recline seat and (3.) loosen strap beneath seat
at point .
WARNING!:ALWAYSputthebuggybrakeon.
To attach travel system
Note:Thebuggyseatdoesnotneedtoberemovedtottravelsystem.
1.
2.
3.
graco_bi_28-07-10.indd 2 29/07/2010 12:49:57 p.m.
Remove carseat from travel system
1. Unbuckle travel system buckle and remove straps from slots on
carseat.
2. Pull up carseat latch handle and lift carseat upwards.
Remove travel system from buggy
Open all four snap locks by lifting up levers and lift travel system off
buggy.
3. Open up all snap locks and press travel
system onto frame so that top snap locks
are directly above sunhood lugs (on both
sides).
5. Passstrapsaroundframe,belowsunhood
lugs and through the slots on each side of
the carseat.
(same slots as for carseat belt)
6. Buckle straps across top of carseat and
tighten by pulling on free end of strap.
4. Closebothsnaplocksdownat,making
sureyouhearthelock‘click’indicating
they are fully locked.
ENGLISH
graco_bi_28-07-10.indd 3 29/07/2010 12:49:57 p.m.
mountain
buggy
®
life without limit
Foranyassistance,pleasecontactyournearestretailerlistedat
www.mountainbuggy.com
ModelMB1-CLIP4
Issue June 2010
Safetycertied:ASTMF833-08
send 102-112DaniellSt,Newtown6021,Wellington,NewZealand
ph +6443800833
fax +6443800137
DesignedinNewZealand.MadeinChina.
graco_bi_28-07-10.indd 4 29/07/2010 12:49:57 p.m.
/