DB Drive E6BE Owner's manual

DB Drive
Brand
DB Drive
Model
E6BE
Type
Owner's manual

This manual is also suitable for

DIGITAL BASS OPTIMIZER
okur
E6 BE
E6BE SPECIFICATIONS & FEATURES
1
Maximum Input Level...............................................................................................12V rms
Maximum Output Level..........................................................................................14V peak
Frequency Response.........................................................................10Hz - 25KHz; +/-1dB
Total Harmonic Distortion..........................................................................................0.002%
Signal to Noise Ratio...................................................................................................127dB
Fuse rating..................................................................................................................1 Amp
• Parametric Bass Equalization
• Variable Center Frequency Control
• Selectable Ground Isolation Switch
• 2 Channel Digital Bass Restoration
• Selectable Balanced / Unbalanced
RCA Input and Output
• Variable Output Gain Control
• Selectable Output Gain Limiter
• Remote Bass Control
• Selectable Sub-Sonic Filter
2 1
3
4
5
6
7
8
9
E6BE FUNCITONS
3
CENTER FREQUENCY: This control allows you to select the frequency you want the E6BE
bass restoration circuit to enhance.
FREQUENCY BANDWIDTH: This control allows you to adjust the range of frequencies from
your center point. All the way to the left will include the maximum frequencies to enhance,
while all the way to the right will enhance only a limited amount of frequencies near your
CENTER FREQUENCY.
OUTPUT GAIN CONTROL: This control allows for you to control the amount of signal you
are sending through the RCA OUTPUTS to your amplifier(s). It is important to note that the
E6BE has a built in line driver capable of sending 9 volts of signal output to your amplifier(s).
GROUND ISOLATION: Alternator whine may appear in the system because the source unit
and amplifier may use different grounds. To help in this situation, we have provided alternative
grounding options have been provided. TURN SYSTEM OFF BEFORE SWITCHING THIS IN
RCA INPUT: In normal cases you will leave the switch in the BALANCED position. In some
systems the source unit may look for a ground through the RCA connections. In this event
you would switch the selection to UNBALANCED.
INPUT: RCA’s from source unit
OUTPUT: RCA’s from the E6BE connect to the inputs of your amplifier(s).
REMOTE: The E6BE Digital Bass Optimizer dash mount control connects here. This remote
allows for complete control of your audible subwoofer level along with a LED indicator which
brightens as you increase bass enhancement.
REM / 12V / GND:
-REM: Connects to a 12V+ switched source.
-12V: Connects to a 12V constant source. (1 amp in-line fuse is required)
-GND: Connects to a chassis ground.
NORMAL SELECTION.
1.
2.
3.
4.
5.
6.
7.
8.
9.
4
E6BE WIRING DIAGRAM
BASS REMOTE
RCA INPUT
BALANCED
20Hz
25Hz
30Hz
FREQUENCY
BANDWIDTH
WIDE NARROW
CENTER
FREQUENCY
SUBSONIC FILTER
Digital Bass Optimizer
UNBALANCED
OUTPUT GAIN
CONTROL
GROUND
ISOLATED
200-OHMS
GROUND ISOLATION
okur
E6 BE
Source Unit
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v VIA
5 AMP FUSE
Amplifier
6
okur
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

DB Drive E6BE Owner's manual

DB Drive
Brand
DB Drive
Model
E6BE
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents