2. Husky Liners
  3. Custom Molded Rear Mud Guards

Husky Liners Custom Molded Rear Mud Guards Installation guide

  • Hello! I've reviewed the installation instructions for the Husky Liners 5915 mud guards. This document provides a step-by-step guide, including details on required tools and necessary parts, such as screws and washers. I'm ready to answer your questions about how to properly install these mud guards on your Jeep Wrangler rear fenders.
  • What tools are needed for mud guard installation?
    What is included in the package?
    What size drill bit is needed to create new holes?
PN: 5915
View the Husky Liners® Lifetime Warranty at www.huskyliners.com/lifetime-warranty. 5915 Jeep Wranglerr Rear Instr.docx
Patent and Trademark can be found at www.hl-ip.com Rev: 0
pg. 1
JEEP WRANGLER – REAR MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
Short Phillips screwdriver
Drill / 1/16” drill bit
8mm socket or wrench
Package Contents
Driver & passenger side mud guard
#10 SEM Screws (qty. 6)
#10 X 1-1/2 Long Screw (qty. 2)
Small Flat Washer (qty. 2)
Instruction sheet
MUD GUARD INSTALLATION
NOTE: It may be necessary to remove the wheels before mud guard installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing fastener from location C.
3. Remove existing U-clip at location C and replace with supplied U-clip.
4. Install the mud guard with the #10 X 1-1/2 long screw and small flat washer at location C. See Figure 1.
5. Using the mud guard as a template, mark and drill 1/8” holes at locations A, C and D.
6. Install #10 SEM Screws at locations A, C and D. Do not overtighten.
7. Check Mud Guard fit and alignment before tightening.
PN: 5915
View the Husky Liners® Lifetime Warranty at www.huskyliners.com/lifetime-warranty. 5915 Jeep Wranglerr Rear Instr.docx
Patent and Trademark can be found at www.hl-ip.com Rev: 0
pg. 2
/