VISUAL COMFORT PCD5100PN-L User manual

Brand: VISUAL COMFORT

Model: PCD5100PN-L

Type: User manual

VISUAL COMFORT PCD5100PN-L is a stylish chandelier that combines modern design with classic elegance. It features a unique offset design with multiple tiers of arms, allowing for a dramatic and eye-catching display of light. The chandelier is crafted from high-quality materials, ensuring durability and longevity. With its adjustable height and multiple bulb sockets, it provides ample illumination and can be customized to suit different room sizes and styles.

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (C) from canopy (F) by unscrewing, then

remove set screw (N) and collar ring (E).

3. Install mounting plate (C) to junction box and secure with mounting

screws (B).

4. Feed electrical and ground wires through bottom rod (I) and connect

to fixture body (J). Repeat for middle rod (H), connecting to bottom

rod (I).

5. Continue feeding wires through canopy (F) and collar ring (E).

6. Holding fixture upright, slide canopy (F) and collar ring (E) down and

rest on fixture body (J). Then connect top rod (G) to middle rod (H).

NOTE: Slide components down slowly to avoid damages.

7. Hang fixture swivel ball (D) to the center of mounting plate (C).

8. Install collar ring (E) to mounting plate (C) and secure set screw (N)

using provided wrench (L).

9. Cut excess wires, being sure to leave enough to reach the junction

box. Separate wires, and strip insulation on each 5/8”.

10. Wrap fixture ground wire (bare copper) around the green grounding

screw (see diagram 1). Tighten. Continue fixture ground wire and

connect to supply ground wire (usually green or bare copper) using

wire nut (A).

NOTE: It is imperative that the fixture is grounded.

Comtesse XL Offset Chandelier

Item # PCD 5100

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED):

Phillips Screwdriver Slotted Screwdriver Wire Cutters

Wire Strippers

NOTICE:

Diagram 1

Bulbs not included

Wrench (L) included

11. Connect fixture neutral wire (white) to the supply neutral wire (usually

white) using wire nut (A).

12. Connect fixture hot wire (black) to the supply hot wire (usually black)

using wire nut (A).

CAUTION: Do not reverse the hot and neutral connections.

13. Make sure all wire connections are tight, then carefully tuck into the

junction box.

14. Thread canopy (F) to mounting plate (C).

15. Install light bulbs into the sockets.

Care Instructions: Clean only with a soft dry cloth or feather duster. Do

Not use abrasive or chemical agents.

Comtesse XL Offset Chandelier

Item # PCD 5100

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

NOTICE:

Diagram 1

Bulbs not included

Wrench (L) included

VISUAL COMFORT PCD5100PN-L User manual

VISUAL COMFORT PCD5100PN-L User manual

VISUAL COMFORT PCD5100PN-L User manual

Related papers

Other documents