2. Pia Ricco
  3. 1JAY-12691
1JAY-12691

Pia Ricco 1JAY-12691, SSL-12691 User manual

  • Hello! I've reviewed the assembly instructions for the Light Fixture. This document provides a comprehensive guide for installing your new fixture, including safety precautions, required tools, electrical wiring information, and step-by-step mounting instructions. I'm ready to answer any questions you have about the installation process or the fixture itself.
  • What should I check before starting the installation?
    What should I do before starting installation or removing previous fixture?
    What is the first step in the installation process?
    What is the purpose of the green ground screw?
Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
CAUTION
Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
EXPLODED PARTS INSTALLATION
STEP 2
Use the mounting screws to attach the mounting unit
to the junction box(not included).
STEP 1
Unscrew the mounting unit, rubber rings and screws
from the fixture.
HARDWARE INCLUDED
FixtureScrews
Screws
Mounting Screws
Mounting Screws
Wire Nuts
Wire Nuts
Mounting Unit
Mounting Unit
Rubber Rings
Rubber Rings
Make the electrical connection from the junction box to the fixture.
Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Then, connect the positive, negative and
ground wires with the supplied wire nuts. Secure with electrical tape.
ASSEMBLY INSTRUCTIONS INSTALLATION
STEP 5STEP 4
STEP 3
Install bulb (not included)Attach the fixture to the mounting unit through screw holes as shown,
and secure it with screws and rubber rings.
NOTICE: Please use caulk in the back plate and wall
mounting surface to prevent water from entering.
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)
/