TODDY Commercial Operating instructions

Type
Operating instructions
TODDY® COLD BREW SYSTEM
COMMERCIAL MODEL
|
ASSEMBLY
WASH BEFORE USE. Make sure the spigot with washer is flush
with the unit. Position the spigot upside down. Screw the nut
with washer on the end of the shank until hand-tight. Continue
to hold the nut and screw the spigot clockwise until it is in its
normal vertical position.
For complete instructions
and to learn more about
Toddy® products, visit
ToddyCafe.com/brewing.
Made in USA of U.S. and imported parts
Loveland, CO 80538 | +1 (970) 493-0788
©2022 Toddy, LLC | Version: 11-2022
Jam Nut
(Inside)
Spigot
Brewing Container Wall
Washer
(Inside) Washer
(Outside)
Jam Nut
(Inside)
Washer
(Inside)
Screw the spigot, the inside & outside washers, and the jam nut
together through the hole in the brewing container wall.
  • Page 1 1

TODDY Commercial Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI