Argos 554/8330 Assembly Instructions Manual

Brand
Argos
Model
554/8330
Type
Assembly Instructions Manual

This manual is also suitable for

Mesh Gas Lift Chair
Assembly Instructions - Please keep for future reference
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Issue 1 - 11/11/16
Dimensions
Width - 41cm
Depth - 47cm
Height - 75-87cm
548/7903
554/8330
1
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product, this
could cause damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Unit weight: 5kgs.
• Maximum safe weight of user:
110kgs.
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Care and maintenance
Handy Hints
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• Do not stand on the chair.
• Do not use this chair as step
ladder.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
2
Components - Parts
Please check you have all the parts listed below
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 6400800
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
105
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Backrest
(36 x 39 x 16cm)
2 Seat
(41 x 38.5 x 6.5cm)
1 Chair lift plate
(25.5 x 13.5 x 6cm)
3
Gas lift
(28/40 x Ø5cm)
4 Base
(Ø28 x 9cm)
5 Castor x 5
(8 x 6.5 x 6.5cm)
6
M6 x 35mm Bolt x 4 M6 x 16mm Bolt x 4 Washer x 4
A DB C
Allen Key x 1
3
Assembly Instructions
Step 1
Attaching backrest
Place the seat upside
down on a raised, flat
and protected surface.
Position the backrest
on the seat as shown.
Secure using bolts
then tighten bolts using
allen key .
D
A
2
1
Step 2
Attaching mounting
plate
Position the mounting
plate onto the seat
as shown.
Secure using bolts and
washers then tighten
bolts using allen key .
Important:
Make sure to
correctly position
the lever at the
right side of the
seat as shown.
3 2
C
D
B
1
2
2
3
A
A
B
C
B
C
B
C
B
C
A
A
B
C
B
C
2
3
B
C
B
C
Lever
A
A
1
2
Arrow
4
Step 4
Attaching gas lift
Place the base on a
flat protected surface.
Insert the gas lift into
the hole on the base as
shown and press firmly to
secure.
Important:
Remove plastic tip
cover on gas lift
before
assembling.
5
4
5
Plastic tip
4
Assembly Instructions
Step 3
Attaching castors
Place the base upside
down on a flat protected
surface. Attach the
castors into holes on
the base and secure by
pressing down firmly.
5
6
6
6
6
6
6
5
Step 5
Assembly Instructions
5
Step 6
Assembly is complete.
Gaslift operation
To adjust the seat higher,
lift up the lever under the
seat and release at
desired height.
To lower the seat, lift up
the lever while seated on
the stool.
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Attaching the seat
Position the seat as
shown and insert the gas
lift into the mounting
plate . Secure by
pressing down the seat
firmly.
4
3
4
3
Lever
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Argos 554/8330 Assembly Instructions Manual

Brand
Argos
Model
554/8330
Type
Assembly Instructions Manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents