PNEUMATIC PUSH BUTTON
INSTALLATION
ACCESS CONTROL PUSH BUTTON WITH
MECHANICAL PNEUMATIC HOLD TIME
HOLD TIME ADJUSTMENT INFORMATION
Hold time adjustment procedure:
There is a slotted brass adjustment screw towards the rear of the timer. Turning this screw clockwise will
increase the hold time interval. Adjust the hold time interval to your desired setting. When using this prod-
uct with electromagnetic locks, local fire codes require either a 30 or 15 second hold depending on the re-
quirements of your jurisdiction.
Like all mechanical pneumatic timers, hold times are approximate and can be affected by environmental
variables. When in doubt, leave a longer hold time to allow for sufficient egress time.
TIME RANGE
2 sec to 60 sec +/- 15%
TIMER LIFE
1 Million tested operaons
TEMPERATURE RANGE
-15 deg F to +120 deg F
Rated for indoor use only.
REPEAT ACCURACY
+/- 5% @ 72 deg F
SWITCH RATING
5 AMP @ 125 VAC
HARDWARE INSTALLATION
The assembly mounts to an aluminum frame with two supplied #6-32 screws. A mounting template is
provided with this product to establish the cutout. Stick the template on the frame and use marked
dimensions for mounting.
ELECTRICAL SPECIFICATIONS
Momentary, adjustable delayed return.
WHITE WHITE
WIRE CONFIGURATION
RED
RED
NC
NC
NO NO
ELECTROMAGNETIC LOCK, NORMALLY CLOSED CIRCUIT
MAGLOCK
RED RED
In this parcular applicaon, the white wires are not used.
White wires may be used for monitoring.
24/7 Tech Support: 1-800-407-4545 | Customer Service: 1-800-523-2462 | General Tech Questions: [email protected] | Tech Docs: www.beasensors.com
75.5831.01
Jamb Style
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Epson RS3 SCARA Robots Installation guide
-
Epson Flexion N6-850 Compact 6-Axis Robots Installation guide
-
-
-
-
Capkold Tumble Chiller CKTC-320 User manual
-
Epson RS3 SCARA Robots User manual
-
-
Epson LS6 SCARA Robots User manual
-
Epson G6 SCARA Robots User manual