PRODUCT DESCRIPTION

BENEFITS/FEATURES

SUGGESTED APPLICATIONS

TECHNICAL INFORMATION

COVERAGE

SHELF LIFE

PACKAGING

Re-Coat Time…………...…………………………4 - 6 hours

Foot Traffic..............................................................24 hours

Wheel Traffic...........................................................24 - 48 hours

Application Temp....................................................45°F - 85°F

When properly sealed and stored, the shelf life of the Armor WB25 is up to 1 year.

The Armor WB25 is available in a 16 OZ Sample, 1 Gallon Bottle, 5 Gallon Pail, and 55 Gallon Drum.

Old or Porous Surfaces 200-250 ft

2

Dense or Trowel Finished Surfaces 250-325 ft

The average coverage rate is 250 FT2/gallon in one coat. Coverage rates will vary depending upon surface porosity and texture, and applica-

tion method. Excessive build up should be avoided.

 Poured, broom finished, and stamped concrete.

 Concrete bricks and pavers.

 Exposed aggregate and some natural stone.

 Do not use on red clay brick without first applying a test area.

 Driveways, walkways, and stairs.

 Pool decks and patios.

 Garage, warehouse, and basement floors.

 Car ports, pole barns, retail and restaurant floors.

COMPLIANCES

 ASTM C 1315, Type 1, Class A

SURFACE PREPARATION: Concrete surface must be clean, dry, and free of any surface contaminants. If applying to a previous-

ed to allow for new sealer to bond. Do not apply if it is expected to rain within 24 hours of applying sealer. When applying to

freshly placed concrete, concrete must be finished and show no sheen from bleed water.

Substrate temperature must be no less than 45 degrees F and not exceed 85 degrees F. If applied outside of these limits, the sealer

may not achieve adequate film formation and may have excessive air entrapment, bubbles, blushing or hazing.

MIXING: Stir well before using. (slow drill mixing or by hand).

Use warm water and soap. Dispose of containers in accordance with local and federal regulations.

Dried, cured sealer may be removed with a commercial paint stripper, or by using a diamond grinding method, sandblasting method or similar

mechanical action.

 If applying indoors, room should be properly ventilated to allow for solvents to evaporate.

 Do not apply over floor adhesives, paints, water based coatings, or incompatible sealers.

 Coverage rates depend upon many conditions including application method, surface porosity, and applicator.

 Please be aware that this product when cured may be slippery when wet.

 Do not apply in early morning if morning dew is present.

 Store product in an area where the temperature is between 50-80 degrees F, and not in direct sunlight.

Still have questions? Contact a Foundation Armor Technician at 866-306-0246.