Hagerco 9130 Series - Heavy Duty Aluminum - I-Beam Track and Hardware Installation guide

Type
Installation guide
Sliding Door Hardware 9110 & 9130 - Pocket
Installation Instructions
I-SD00328
Rev 2, Rev Date: 2/13/18 Page 1 of 2
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
1 PREPARE OPENING
OPENING HEIGHT MAX = DOOR HEIGHT + 4-1/4
OPENING HEIGHT MIN = DOOR HEIGHT + 3-1/2
CONTENTS
9110
9130
1. TRACK (9101)
2. CARRIER
3. DOOR MOUNT PLATE
4. FLOOR GUIDE (9115)
5. #10 X 1-1/2” PPHS
6. #6 X 7/8” FPHS
7. #12 X 1-1/4” PPHS
8. RUBBER BUMPER (9881)
(sold separately)
9. PULL
(Sold separately)
1
2 (9102)
2
1
20
4
8
1
1
1
2 (9105)
2
1
20
4
8
1
1
2. (9105)
4.
3.
1.
2. (9102)
6.
7.
5.
8.
3.
Sliding Door Hardware 9110 & 9130 - Pocket
Installation Instructions
I-SD00328
Rev 2, Rev Date: 2/13/18 Page 2 of 2
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
2 INSTALL TRACK AND HANGERS
Center track in opening and secure with (#10x1-1/2”) screws
Leave a 1” gap between opening end of track and door frame to
allow for removal of carriers
Center quick release plates on door thickness
Mount pocket plate edge 3/4” from near pocket door edge
Mount opening plate edge 1-1/2from opening door edge
Secure Carriers onto door with (#12 x 1-1/4”) screws
3 HANG DOORS
4 ADJUST AND FINISH
Cut a kerf 1/4” X 9/16” deep in bottom of door
Install door guide directly under track and as far into
pocket as practical using (#6 X 7/8”) screws
Open quick release latches on brackets
Slide door onto carrier and close hatch
Adjust carriers so door is square with frame
Drill appropriate dimensioned hole to mount door pull
(optional)
Install stops (optional)
Pocket end
Opening end
  • Page 1 1
  • Page 2 2

Hagerco 9130 Series - Heavy Duty Aluminum - I-Beam Track and Hardware Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI