Emac NGRIPVAM Installation guide

Type
Installation guide

This manual is also suitable for

TECHNICAL FILE
R03.001_27/02/2015
Technical information
Emac Complementos S.L. (Spain) info@emac.es // Emac America L.L.C. (FL,USA) [email protected] // Emac Italia S.R.L. (Italy) [email protected]
www.emac.es
You can nd out more information about the technical features of the Emac®’s products by downloa-
ding its Technical Files in www.emac.es.
If you have any query, please contact our Technical Department in tecnico@emac.es.
The data provided are for information only and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
Novogrip Access
Cleaning and maintenance
Page 2 of 2
Interiores Pavimentos
Installation
Novogrip Access is easy to install on nished oorings with adhesives. It is recommended using an
acrylic double-side tape reinforce with a mesh.
For installation in porous oorings, it is highly recommended the use of a primer, specially in surfaces
with anti-grafti or anti-stain treatment.
1. Clean the surface to install the Novogrip Access and check that is free from dust or grease.
2. Be sure that both Novogrip and ooring are dry and in good state of preservation before proceeding.
3. Apply the double-side tape on the rear of the tiles
4. Remove the protective lm of the adhesive and glue the Novogrip on the desired surface. Put pres-
sure to get an optimal adhesion.
5. Clean the leftover material and let dry.
In case of installing Novogrip outdoors, be sure that is under cover and always protected from
direct sunlight. To install it, proceed as described but using a nitrile contact glue instead the double-
side tape. Make always a previous test to verify the adhesive.
Technical Features and tests
Reaction to re C
- s1 EN 13501-1
The cleaning can be done with water and detergent or specic cleaner diluted. The correct use of
bleach do not affect PVC. In case of doubt, always make a previous test on a less visible area.
It is not recommended using chromic acid, sulfuric acid or organic solvents as ethyl acetate, acetone
or toluene.
  • Page 1 1

Emac NGRIPVAM Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI