TECHNICAL FILE

R03.001_27/02/2015

Technical information

Emac Complementos S.L. (Spain) info@emac.es // Emac America L.L.C. (FL,USA) [email protected] // Emac Italia S.R.L. (Italy) [email protected]

www.emac.es

You can nd out more information about the technical features of the Emac®’s products by downloa-

ding its Technical Files in www.emac.es.

If you have any query, please contact our Technical Department in tecnico@emac.es.

The data provided are for information only and have been obtained by our supplier or Emac®.

Novogrip Access is easy to install on nished oorings with adhesives. It is recommended using an

acrylic double-side tape reinforce with a mesh.

For installation in porous oorings, it is highly recommended the use of a primer, specially in surfaces

with anti-grafti or anti-stain treatment.

1. Clean the surface to install the Novogrip Access and check that is free from dust or grease.

2. Be sure that both Novogrip and ooring are dry and in good state of preservation before proceeding.

3. Apply the double-side tape on the rear of the tiles

4. Remove the protective lm of the adhesive and glue the Novogrip on the desired surface. Put pres-

sure to get an optimal adhesion.

5. Clean the leftover material and let dry.

bleach do not affect PVC. In case of doubt, always make a previous test on a less visible area.

or toluene.