Intermec PB41A27040 Installation guide

Type
Installation guide

This manual is also suitable for

Installation
Installing 802.11b
Radio Card in the
Instructions
PB41 Printer
2 Installing 802.11b Radio in PB41 Printer Instructions
Packing List
Checktoensurethatyoureceivetheseitems:
S Intermec
R
PB41A27040 or PB41A27042 (4-inch thermal
belt ) Printer with 802.11b radio
S 802.11b Radio Card (taped to th e inside of the printer box)
Introduction
Your PB 41 Printer with an 802.11b radio has been configured
at the factory. FCC mandates that the radio card not be
installed for shipment. The following information guides you
through the process of installing the radio card.
The radio card is packed separately in a static plastic bag
taped to t he inside of the printer box.
Installing 802.11b Radio Card
Before installing the 802.11b Radio C ard ensure
that the protective battery tab strips are in place
or remove the batteries before installing the radio
card in your PB41 Printer.
1 Remove the radio card cap.
3
Installing 802.11b Radio in PB41 Printe r Instructions
2 With the logo facing down, insert the radio card between the
foam and the radio card strap.
3 Carefully push the card into the connector until it is fully
seated.
4 Replace the radio card cap.
5 Install the battery packs.
4 Installing 802.11b Radio in PB41 Printer Instructions
Corporate Headquarters
6001 36th Avenue West
Everett, Washington 98203
tel 425.348.2600
fax 425.355.9551
www.intermec.com
*962000038A*
PN: 962000038A
Installing 802.11b Radio in PB41 Printer Instructions February 2004
U.S.A.
E 2004 by Intermec Technologies Corporation. All rights reserved.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Intermec PB41A27040 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI